b d KPX-7 Wireless Keypad Instruction Manual
- June 13, 2024
- b d
Table of Contents
b d KPX-7 Wireless Keypad
FACTORY PIN: Keep in safe place and retain for future use.
OPEN THE PACKAGING
STEP ONE
ACTIVATE: The CODE SET mode on the garage door pener by;
CODE IN THE KEYPAD
STEP TWO
The garage door opener will indicate that CODE SET has been completed.
CONTROLLING THE GARAGE DOOR
STEP THREE
Pressing Button 1 again within 10 seconds wil control the garage door again.
CREATE YOUR OWN PIN
STEP FOUR
This PIN will now operate the keypad instead of FACTORY PIN. Keep the FACTORY PIN in safe place as this is required to FACTORY RESET the keypad.
ADDING ADDITIONAL PINS
Up to 29 additional PINs can be added
Three long beeps after pressing button 2, indicates memory is full.
The Keypad will give a long beep to indicate the PIN has been accepted.
The new PIN can now operate the door.
CODE SET OTHER KEYPAD BUTTONS
The Keypad buttons can be programmed to perate other functions or devices.
ACTIVATE: The CODE SET mode on the garage door or device
All users can now enter their PIN followed by the programmed number button to control device.
CHANGING A PIN
The new PIN can now operate the door.
DELETING A PIN
NOTE : If the last PIN in the memor y is deleted then the keypad is
factor y reset.
Refer to CREATE YOUR OWN PIN to star t again.
refer to bnd.com.au for extended programming
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>