eplus Specialized KIT MINI Kit Advanced Instruction Manual
- June 13, 2024
- eplus
Table of Contents
+ SPECIALIZED
MANUAL
KIT MINI – KIT ADVANCED
2. INSTALLATION
PRODUCT WARRANTY
- 24 months warranty.
- It fears humidity and heat sources.
- We are liable for manufacturing defects and not for incorrect installations.
- Any firmware update, previous modification with other systems, alteration or damage to the bicycle could result in the failure of the product which can therefore neither be replaced nor refunded.
Eplus guarantees that the product does not have any original conformity defects, pursuant to Legislative Decree 206/05. The function is guaranteed up to the latest version of the original engine; before updating the ebike check compatibility.
ATTENTION
Unlocking the speed limiter in public places such as streets, squares, cycle
paths is PROHIBITED BY LAW. Therefore it is possible to activate the release
in private limited places such as circuits, tracks and private properties.
Fitting the device may void the bicycle’s factory warranty. The manufacturer
declines all responsibility for any damage caused to the pedal assisted
bicycles on which the Eplus system is mounted. The manufacturer declines all
responsibility for damage to persons or things caused or in any way related to
the use of Eplus.
ALL TRADEMARKS MENTIONED IN THIS MANUAL ARE THE PROPERTY OF THEIR RESPECTIVE
OWNERS.
SPECIALIZED, TURBO LEVO, TURBO VADO, WINDOWS, DO NOT SUPPORT, DO NOT SPONSOR,
ARE NOT IN ANY WAY TO BELIEVE RELATED TO OUR COMPANY.
PRELIMINARY CHECK
The following tools may be required for the installation of the Eplus kit. We recommend a preliminary check of your ebike:
- Torx wrench
- Allen key
- Crank arm extractor
- Cross screwdriver
- Long nose pliers
- Phon
INSTALLATION PROCEDURE
The installation procedure of the Specialized Mini – Advanced kits always
takes place in the same way.
NOTE: Depending on the kit installed (Mini – Advanced) some functionality
may vary.
SPECIALIZED INSTALLATION KIT
MINI – ADVANCED
Before starting, disconnect the battery.
Remove the crank arm from the opposite side of the transmission with a puller.
Using long-nosed pliers, disconnect the 5-wire connector of the on-board computer on the motor side. Then, disconnect the 2-wire connector on the motor side of the speed sensor.
LOCATE THE CONNECTORS
Connect the connectors as shown at pag. 8
ATTENTION, AN INCORRECT CONNECTION CAN CAUSE SHORT CIRCUIT, DAMAGE NOT COVERED
BY WARRANTY!
ASSEMBLY DIAGRAM
It is necessary to apply hot glue between the connectors so that they do not come off.
SPECIALIZED KIT MINI
In the MINI version, only the most important function will be offered: speed
unlock e pedal assistance up to 50 km/h.
NOTE: The kit is basic because the modification is always active and the
data shown on the display are not correct.
SPECIALIZED KIT ADVANCED
SPEED UNLOCK
The activation / deactivation of the speed unlock is done via the “Walk”
button; For bikes equipped with the new HMI with display, 2.2 in case of
activation and 1.1 in case of deactivation will be displayed.
The Advanced kit for Specialized is combined with the use of the Eplus Tuning
app; Among the various customizations, the app allows you to:
– Choose from 6 different mappings
– Unlocking the speed
– View all data correctly
– Set the wheel size from 2000 mm to 3000 mm
– Activate the Code Immobilizer (anti-theft function)
– Set a value up to 75 km / h for the speed (theoretical)
– Set the active unlock when the bike is turned on
EPLUS TUNING APPLICATION
Application available ONLY for Specialized Advanced kits.
NOTE: For those in possession of the old Lite version, purchased before
31/10/21, HERE the link to the reference manual.
|
---|---
https://cutt.ly/4RKOpBd| https://cutt.ly/IRKOYey
support@eplus.bike
www.eplus.bike
Via Pontestura 124 Camino 15020 (AL) Italy