Nofence AS 2A3V8C25 C25 Cattle Collar SG25 Sheep Goat Collar User Guide
- June 13, 2024
- Nofence AS
Table of Contents
AS 2A3V8C25 C25 Cattle Collar SG25 Sheep Goat Collar
User Guide
FCC USA Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Nofence has not approved any changes or modifications to this device by the
user. Any changes or modifications could void the user’s authority to operate
the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Contains FCC ID: XPYUBX20VA01, ISED ID: 8595A-UBX20VA01 with an integrated
antenna.
This product emits radio frequency energy, but the radiated output power of
this device is far below the FCC radio frequency exposure limits.
This equipment complies with FCC RF radiation exposure limits for an
uncontrolled environment. Nevertheless, the device should be used in such a
manner that the potential for human contact with the antenna during normal
operation is minimized.
In order to comply with FCC RF Exposure requirements, this device must be
installed to provide at least 20 cm separation from the human body at all
times.
Contact us
ISED Canada Compliance Statement
https://www.manula.com/manuals/nofence-as/master-user-guide/1/en/topic/fcc- usa-compliance-statement
References
- Contact us - Master User Guide - 2023
- FCC USA Compliance Statement - Master User Guide - 2023
- ISED Canada Compliance Statement - Master User Guide - 2023