RUROC RG1 DX Magloc Goggles User Guide
- June 13, 2024
- RuRoc
Table of Contents
MAGLOC GOGGLE
INSTRUCTION MANUAL
READ BEFORE USE!
RUROC.COM
RG1 DX Magloc Goggles
WARNING
This goggle meets or exceeds some of the world’s most demanding safety
standards for snow sport goggles. This goggle is designed to protect the
wearer from UV-rays, wind, moisture and snow. The goggle gives limited
protection in case of impacts against hard or sharp objects. No goggle can
offer complete protection against injury or death in an accident, even at low
speeds, so it is important that you ensure you wear this goggle correctly and
take all necessary precautions to ensure your safety, including riding within
your skill level and abilities. This is your responsibility. This goggle is
for non-motorized recreational snow-sport such as snowboarding, skiing and
other alpine sports and should not be used when riding motorized vehicles as
snowmobiles and motorbikes. Do not use this goggle in road traffic.
FILTER CATEGORIES
The filter category of your lens is marked on the lens.
S0| 80% – 100% visible light transmission for use in very low light
conditions
---|---
S1| 43% – 80% visible light transmission for use in low light
conditions
S2| 18% – 43% visible light transmission for use in medium sunlight
conditions
S3| 8% – 18% visible light transmission for use in bright sunlight
conditions
S4| 3% – 8% visible light transmission for use in very bright
sunlight conditions
INTENDED USE
Area of application, protective effect. This goggle is for nonmotorized winter sport use only and is designed to protect the wearer from UV-rays, wind, moisture and snow.
Antifog
The goggle is is equipped with a special anti-fog inner lens to prevent
fogging. This inner lens is very sensitive and should not be touched or
rubbed. The lens will lose its anti fog characteristics.
If snow or water enters the goggle, shake all snow and water out and then let
the goggle air dry. In exceptional cases use the microfibre bag and gently
blot the inside of the lens.
Approved spare parts and accessories
For approved accessories contact your authorized Ruroc dealer or customer
service. Do not change or remove any parts of the goggle.
GOGGLE CARE
Cleaning
Follow the below points to maximise the performance and longevity of your
goggle.
- Cleaning the frame foam and head strap: use plenty of clear water and a mild soap;
- cleaning the lens: only use plenty of clear water and if needed use the enclosed microfibre bag as cleaning cloth;
- do not use detergents, cleaning agents or other chemicals;
- do not use paper or abrasive cloth as it may scratch the lens;
- let the lens and goggles air dry. Do not use hot air (e.g. hair dryer);
- do not touch or rub the inside of the lens as it will destroy the anti-fog functionality.
Storage
- Do not store goggle when wet. Allow the goggle to fully air dry before storing;
- store the dry goggle in the enclosed microfibre bag on a dry and warm place;
- do not use a goggle which was stored in a subzero place overnight (e.g. in the car);
- do not expose the goggle to extreme heat or sunlight.
FITTING INSTRUCTION
Wear and adjust your helmet on your head. Then place the goggle over your eye
area and pull the strap over the helmet and secure it under the goggle clip on
the back of the helmet.
Enlarge or shorten the strap if necessary. The goggle should lay firm but
comfortable on your face.
WARRANTY INFORMATION
Ruroc warrants all products to be free of defects in material or workmanship
for a period of one year from the date of purchase, subject to the provisions
below.
If a Ruroc product fails due to defects in craftsmanship or materials, within
the warranty period, we will repair or replace the product free of charge
provided that you promptly notify us of any defect (in any event within 7
days) and you immediately cease to use the product in question. Be aware that
this warranty is limited to the original purchaser only. For detailed
information please see the guideline below and/or the product specification
following the product.
If you have any questions regarding our products or the above warranty, please
feel free to contact our service centre by e-mail at:
info@ruroc.com
WARRANTY PROCESS:
- Before returning any product please contact Info@ruroc.com and a member of the team will be able to arrange a pre-paid return labels for you to send the product back to us.
- Ensure that the returned product is washed, cleaned and dried before shipping. Dirty and/or foul smelling helmets will be returned unprocessed, or may delay the process with an additional surcharge.
- Remember to include a note with your name, address and phone number, AND fill out the returns form. Please make sure to include a short statement explaining the warranty problem.
Alternatively, you may also return your product to the store from where you originally purchased the product. Any Ruroc dealer is able to handle the warranty process on your behalf.
NOTE: Damage due to wear and tear, accident, misuse, or neglect, or if
you fail to store or use a product other than in accordance with the
instructions provided, or damage due to
any repairs carried out by you or a third party not authorised by us, is not
covered under warranty. Please contact our warranty department if you have any
questions.
EU-TYPE & UK TYPE
EXAMINATION CONDUCTED BY:
TAICANG ACT SPORTING GOODS TESTING CO.
NO. 35 ZHENGHE ROAD TAICANG CITY SUZHOU, JIANGSU PROVINCE 215412 CN
BSI GROUP THE NETHERLANDS B.V.
SAY BUILDING, JOHN M. KEYNESPLEIN 9, 1066 EP
AMSTERDAM, NETHERLANDS CE NOTIFIED BODY NO: 2797
BSI ASSURANCE UK LIMITED DAVY AVENUE KNOWLHILL, MILTON KEYNES MK5 8PP UNITED
KINGDOM
UKCA NOTIFIED BODY NO: 0086
Designed in the UK:
Ruroc Ltd, 2 Barnett Way
Barnwood Estate, Gloucester
United Kingdom
GL4 3RT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>