HAVIT HV3621 Mini and Mini Louvre Wall Light Instruction Manual

Table of Contents

HV3621 Mini and Mini Louvre Wall Light
**Instruction Manual

**

****Mini & Mini Louvre Wall Light
Installation Instructions

Model No.	HV3621T-BLK I HV3621T-SS316	HV3622T-BLK	I HV3622T-S5316
Name	Mini	Mini Louvre
Material		316 Stainless Steel
Colour	Black	Stainless Steel	I Black
IP Rating		1P54
Input Voltage		240v AC
Protection Class		1 (240v Requires Earth)
Lamp Base		0.00E+00
Lamp Wattage		lx 9w
Colour Temp		TRI Colour – 3000k, 4000k, 5500k
Lumens		7001m, 720lm, 740lm
CRI		> 80
Wiring		Parallel
Dimmable		No
Warranty		3 Years Replacement*

This product must be installed by a qualified electrician according to AS/NZS 3000.
Ensure all electrical mains are disconnected before any installation.
Modification of this product will void any warranty.
Havit Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
All 316 & 304 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting. (Warranty does not cover Tea Staining)
All o-rings and seals must be in place correctly to maintain a warranty
This form may be updated at any time due to product improvements, please check the online installation form for the most current version.

Make sure that the electrical circuit is free of voltage (master switch off )
Remove nuts from the front of the fitting and set them aside.
Remove base plate from fitting.
Install the base plate to the wall in the desired location.
Connect the cable – use wire with earth; connect the earth first, then live and a neutral wire.
Seal all holes including cable entry and around screws to avoid any water penetration.
Reattach fitting to base plate making nuts tight to avoid water penetration.
Seal around the base plate using silicon to avoid any water from getting into electrical connections.
The Colour temperature is set to 3000K. To change, remove the cover from the fitting by twisting anti-clockwise. for HV3621 models, remove the 2x nuts and washers and put them aside. Remove globe by also twisting anti-clockwise and select desired color temperature by moving switch on side of the globe and then reinsert globe.
Reattach the cover by turning clockwise and for HV3621 Models, reattach the 2x nuts first, making sure the seals are still in place and the cover is tight to avoid any water penetration.
Apply silicon around the edge of the fitting to prevent any water from getting inside to electrical connections.
All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.

Remove cover from the fitting by twisting anti-clockwise. for HV3621 models, remove the 2x nuts and washers and put them aside Remove the globe by also twisting anti-clockwise.
Re-insert the appropriate globe by twisting clockwise into the lamp holder (Make sure not to exceed max wattage, see product label for correct info)
Reattach the cover by turning clockwise and for HV3621 Models, reattach the 2x nuts first, making sure the seals are still in place and the cover is tight to avoid any water penetration.

Contact Details:

143 Beauchamp Road Matraville NSW 2036
Australia| Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
---|---
Warranty Terms & Conditions*| Additional Information
---|---
|
https://havit.com.au/pages/warranty-terms-and-conditions| https://havit.com.au/