ALIGN 212052 Pendant Ceiling Light Instruction Manual
- June 12, 2024
- align
Table of Contents
ALIGN 212052 Pendant Ceiling Light
Product Information
This product is a lamp that has an IP20 rating, which means it is protected against solid objects greater than 12.5mm in diameter and does not have protection against water. It is classified as Class II, which means it has double insulation and does not require grounding. The lamp has a maximum wattage of 15W. It is important to follow the specified wattage to avoid damaging the lamp. The user manual also provides instructions for the proper disposal of the product.
Product Usage Instructions
Mounting
The lamp should be mounted using the included screws. Ensure that the lamp is
securely attached to the desired location.
IP20 Rating
The lamp should only be installed in areas where direct contact with water
cannot occur. This ensures the safety and functionality of the lamp.
Maximum Wattage
Do not exceed the maximum wattage of 15W when using this lamp. Using higher-
wattage bulbs can cause damage to the lamp.
Class II
This lamp has double insulation and does not require grounding. Therefore, it
is not necessary to connect it to the ground wire of the electrical system.
Disposal
When disposing of this lamp, follow the proper waste disposal procedures. Do
not dispose of it with regular household waste. Take it to a designated
electronic waste collection point or contact your local waste management
service for guidance on proper disposal methods.
Please note that these are general usage instructions based on the provided information from the user manual. For specific installation and usage instructions, refer to the complete user manual that came with the product.
MOUNTING INSTRUCTIONS
IP20: The lamp should only be installed in areas where direct contact with
water cannot occur.
Class II: The lamp is double-insulated and does not need to be connected to
the yellow/green earth wire
The lamp is only suitable for connecting directly to the mains.
The mounting instruction must not be discarded.
Do not exceed the maximum wattage
IMPORTANT!
Always shut off power to the circuit before starting installation work. In some countries, electrical installation work may only be carried out by an authorized electrical contractor. Contact your local electricity authority for advice.
Disposal of waste equipment by users in private households in the European
Union. This symbol indicates that this product must not be disposed of with
your other household waste. Electrical and
electronic equipment contain substances that may cause damage to human health
and the environment if not recycled correctly. It is your responsibility to
hand over to a designated collection point for recycling of waste electrical
and electronic equipment. When handing over for correct recycling you help to
prevent these products from straining nature and the environment unnecessarily
and to protect human health. For more information regarding correct disposal,
please contact your local city to purchase this product.
Z-connection: The wire cannot be replaced if damaged, and the lamp must be discarded.
General maintenance: Use a soft, dry cloth for dusting, and a soft, damp cloth to gently remove grease or similar stains. Never use any detergents or chemical reagents. Do not switch on the lamp before all the water has evaporated. Specifically for mouth-blown glass: Mouth-blown glass is formed manually. Because of this unique process, air bubbles may occur in the glass, just as the thickness of the glass may vary. This is to be seen as a natural consequence of the manual process and is what gives the mouth-blown glass its character and organic look. Always clean mouth-blown glass when the glass is cold