Orangetheory OT-BURN-3.0-C OTbeat Burn Heart Rate Monitor User Guide
- June 12, 2024
- Orangetheory
Table of Contents
Orangetheory OT-BURN-3.0-C OTbeat Burn Heart Rate Monitor
Product Information
The OTbeat Burn is a fitness device that tracks heart rate and is designed to be used in conjunction with the Orangetheory App. It comes with two bands (SM and LG) and a USB cord for charging. The device has LED lights that indicate heart rate detection, Bluetooth connection state, and battery status. It can be charged using a regular USB connector and can also be connected directly to a computer for charging. The device is worn on the bicep with the module facing away from the body to ensure accurate data transmission.
Instructions for
- Getting Started
- Downloading the Orangetheory App
- Charging Device
- Proper Placement
- Pairing Device
- LED Guide
- Caring for Device
- Technical Specifications
Getting Started
- Included in packaging: OTbeat Burn, SM band, LG band, & USB cord
- Remove OTbeat Burn from packaging
- Connect USB cord into charging port of device to wake the device from manufacturing sleep mode
- LED light will appear after a few seconds
Downloading the Orangetheory App:
Note: Fully charge device before attempting to pair for the first time.
Charging Device
- Open rubber port cover on back of device
- Plug in mini-USB connector into device port
- Plug in regular USB connector into charging block (not provided)
- Plug in charging block into wall outlet
- Device can be connected directly to a computer USB port for charging. Note: Charging time will vary due to differences in voltage between wall outlet and computer.
- Battery is fully charged when Green LED is continuously on During charging: Red LED light will blink slowly
- LED indication for charging is on front of device
Proper Placement:
To transmit accurate data from your device:
- Fasten device snugly around the bicep with the module pointing away from the body.
- The optical sensor should make good contact with skin
Pairing Device
-
Once OTbeat Burn is fully charged, double click the center of the Splat to power ON the device
- Set power ON: Short button press (Blue LED blinks for 5 seconds)
- Set power OFF : Long button press (Red LED light blinks quickly for 5 seconds then turns off)
-
Launch the settings app on your mobile device
-
Ensure your bluetooth settings are on
-
Open Orangetheory app on mobile phone.
-
Use the Orangetheory app to search for device
Once device appears, OTbeat Burn is successfully connected to app
LED Guide:
- Heart Rate Detection LED Indication:
- Alternating BLUE and GREEN: Detecting heart rate Alternating BLUE and RED: No heart rate detected Blinking GREEN: Heart rate detected
- Blinking ORANGE: Heart rate zones are changing
- Bluetooth Connection State:
- Blue LED blinks for 5 seconds: After turning on the unit
- Blue LED continuously on for 5 seconds: Connected
- Green LED continuously on: Updating firmware
Battery LED Light
- During Charging
- Red LED blinks slowly : Charging
- Green LED continuously on: Battery full
- Battery State
- Red LED blinks three times : Low battery at <15% (repeat every 5 min. until reach critical level)
- Red LED continuously on for 2 sec : Device powering off
Caring for Device
- To ensure accurate readings, clean the sensors with a soft cloth after use
- OTbeat Burn unit and strap are waterproof to IP67 specifications and can be easily cleaned with mild soap and cool water
- Use a cotton swab and rubbing alcohol to clean the USB charging contacts when necessary. Do NOT contact USB charging port
- Do not use any abrasive chemicals to clean the OTbeat Burn unit, sensor, or strap. This will cause permanent damage
Technical Specifications
For more information visit orangetheory.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>