DS18 SLG-WFCC8 Polaris Slingshot Waterfall Center Console Pod for 8 Inch Speakers and 3.8 Inch Bullet Tweeter Owner’s Manual
- June 12, 2024
- DS18
Table of Contents
SLG-WFCC8 Polaris Slingshot Waterfall
Center Console Pod for 8 Inch Speakers and 3.8 Inch Bullet Tweeter
Owner’s Manual
OWNER’S
MANUAL
SLG-WFCC8 Polaris Slingshot Waterfall Center Console Pod for 8 Inch
Speakers and 3.8 Inch Bullet Tweeter
SLG-WFCC8
POLARIS SLINGSHOT WATERFALL CENTER CONSOLE POD FOR 8” SPEAKERS & 3.8” BULLET
TWEETER
INTRODUCTION
If you’re looking to maximize sound in your Polaris Slingshot, you may consider adding this durable Polyethylene Waterfall Center Console Pod by DS18. This pod allows you to mount one 8″ Speaker (not included) and one 3.8” Super bullet tweeter (not included) that your stereo system deserves. This pod comes with a black textured finish to match the factory’s look. Very easy to Install using supplied bolts that fits directly into place.
FEATURES
- Easy to install with all hardware included.
- Fits only on 2015-2019 Slingshot models.
- Fits any 8” DS18 Speakers (not included).
- Fits any 3.8” DS18 bullet tweeter. (not included)
- Durable (PE) waterproof Panel with UV Protection.
- Black OEM Finish
SPEAKERS PARAMETERS
- Speaker Mounting hole: 7.16” / 182mm.
- Speaker Mounting Depth: Up to 4.3” / 110mm.
- Tweeter Mounting hole: 2.9” / 74mm.
- Tweeter Mounting Depth: Up to 4” / 101.6mm.
WHAT’S IN THE BOX
- One empty pod / panel
- Screws and washers.
INSTALLATION
Remove the factory 12V port pushing down the clips and disconnect it, also
remove the cup holder to gain more room and seat properly. (Picture 1)
Place
the pod in place and mark the holes to open at the sides, use a drill with a
1/8” bit and open the holes for the screws. (Picture 2) 
Then
secure the pod (Picture 4) and reconnect the 12V port in the new hole position
and re-connect it. (Picture 3) 
This kit needs an aftermarket amp pre-installed with
the speaker wires in this location, only after this step can you install the
speakers using the aftermarket amp’s speaker wire and RGB LED wires (optional)
of the LED module (LED -BTC not included).
Install the speakers using the speaker wires previously installed, use the
same line to connect the tweeter and make sure to use a bass blocker filter
to it, if you are using RGB led speakers connect it to the RGB wiring harness.
Secure the speakers using stainless steel screws and tighten them, be careful
not to over-tighten or the hole may be damaged and not properly secure the
speakers.
This concludes the installation of the SLG-WFCC8 and it is ready to enjoy your
new sound system upgrade!
MEASUREMENTS
WARRANTY
Please visit our website DS18.com for more information on our warranty policy.
We reserve the right to change products and specifications at any time without
notice.
Images may or may not included optional equipment.
**** WARNING:
Cancer and Reproductive Harm.
www.P65Warning.ca.gov
FOR MO RE INFORMATION
PLEASE VISIT DS18.COM 
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>