MCONFORT IC 18000 Evaporative Air Conditioner User Manual

MCONFORT IC 18000 Evaporative Air Conditioner

Dear Customer:

We want to thank the trust placed in us and welcome you to the comfort and convenience that your MCONFORT device will shortly provide. We remain at your disposal to answer any questions about the characteristics and operation of your equipment. We hope you enjoy the benefits of your MCONFORT device. We are a quality brand that takes care of details and seeks the highest customer’s satisfaction.

Yours sincerely:

MCONFORT team

MAIN COMPONENTS

Device main components:

Control panel and remote:

Electric scheme:

TECHNICAL SPECIFICATIONS

GENERAL RECOMENDATIONS

Evaporative coolers work by passing a flow of air through cooling filters, which are saturated with water, so that by increasing their relative humidity they lower air’s temperature. They convert hot, dry air into cool, humid air. In addition, the fact that they filter the air serves to purify the atmosphere and improve air quality.

To achieve maximum cooling and air quality, consider the following recommendations:

1. Use the equipment in well-ventilated places. If used in a confined or poorly ventilated space, the performance of the equipment may be greatly reduced and it will be very difficult to lower the air temperature.
2. Try to place the equipment with your back to an open door or window, so that as much new air as possible entering the room passes through our equipment. This will increase the performance of the equipment and improve the quality of the air we breathe.
3. Keep equipment filters clean. The cleaner they are, the more cooling and air filtering power our equipment will have.
4. Change the water in the tank as soon as you detect that it contains dirt. Part of the airborne particles passing through the filters can end up in the water tank. Using equipment with dirty water decreases performance, worsens air quality and can create operational problems.
5. Before storing the equipment, make sure the filters and the reservoir are clean and dry.
6. Do not put any liquid into the reservoir other than water. Mixing chemicals with water can endanger the health of people, animals and plants, as well as damage the cooling filters.

SAFETY WARNINGS

1. Please read user’s manual carefully before use.
2. This product is only applicable to 220-240V, 50Hz, AC power supply.
3. Stop operating this air cooler immediately if it works abnormally and contact technical service center. User must not unassembled or repair the machine.
4. If the power cord is damaged, it must be replaced only by the manufacturer or technical service center.
5. The power cord shall not be scratched, damaged, over bent, pulled, twisted, or pressed with heavy objects, otherwise it may cause electric shock, short circuit and fire.
6. This machine must not be placed in a place accessible to children. Children must not use the machine. Children shall not play with the appliance.
7. Please do not insert your hand or any object into air outlet, or filters.
8. The machine should not be placed in uneven surfaces, do not leave screws or other miscellaneous items in the fan. There should be no curtains or anything like that behind the fan.
9. Do not cover this appliance when its working.
10. Please place the machine on a horizontal surface for use, so as not to fall down and damage the internal components.
11. This appliance is only for indoor use or protected outdoor use. Do protect the equipment from wet floors, splashes of water, rain, etc.
12. Do not use the machine around the bathroom, swimming pool or wet places. This product should not be immersed in water under any circumstances.
13. When the machine is running, it is forbidden to block the air outlet and the air inlet through the filter part.
14. Do not permit the area around the humidifier to become damp or wet. If dampness occurs, turn the output of the humidifier down. If the humidifier output volume cannot be turned down, use the humidifier intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to  become damp.
15. Please keep the device filters and water tank clean.
16. Unplug the appliance during filling and cleaning.
17. In order to prolong the product life, please do not use it in extremely hot, damp or places with oil and dust, and do not use it beside the fire or inflammable articles, so as to avoid fire.
18. Never leave water in the tank when the machine is not in use. Empty, clean and dry the machine before storage.
19. Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
20. Do not ingest battery, Chemical Burn Hazard. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death.
21. If the battery compartment does not close securely, stop using the product and keep it away from children.
22. Keep new and used batteries away from children.
23. The remote controller should be used properly. Avoid shocks or water immersion. Pay attention to the polarity when installing the battery.
24. The batteries contain materials which are hazardous to the environment; they must be removed from the appliance before it is scrapped and be disposed of safely.
25. It is not recommended to use the equipment in temperatures below 18ºC and above 45ºC.

USE INSTRUCTIONS

1. Fill the water tank. You can fill the tank through the manual filling hatch or by connecting the equipment to the network (if the network has a lot of pressure, it is recommended to install a pressure reduction valve). If the water level in the tank is very low, a red light will flash on the control panel.

2. Connect the power cord.

3. Press POWER to turn on/off the equipment.

4. Press COOL/FAN to turn evaporative cooling on/off. When the evaporative cooling is deactivated, the unit works like a fan (BLAST).
   Note that when we activate the evaporative cooling, the unit takes a while to soak the water filters before starting to cool the air.

5. Press SPEED to select one of 3 fan speeds: low, medium, or high.

6. Press SWING to activate/deactivate the horizontal air swing function.

7. Press TIMER with the equipment turned off to program the automatic ignition of the equipment from 1 to 24 hours.

8. Press TIMER with the equipment turned on to program the automatic shutdown of the equipment from 1 to 24 hours.

CLEANING AND MAINTENANCE

ALWAYS unplug the power cord before maintenance.

EQUIPMENT CLEANING:

Clean the surface of the appliance with a soft, damp cloth. Do not allow water to fall inside the machine.

Please note that the surface should not be polished with sandpaper, waxed, cleaned with gasoline, acid, alkali, benzene and other organic solvents to avoid discoloration and deterioration.

WATER TANK CLEANING:

Unscrew the drain cap to let the dirty water out, then wipe the water tank well with a soft cloth. Wash dirt from the water sensor, water pump and float valve. Rinse well.

FILTER CLEANING:

Remove the filter by unscrewing the 4 screws at the rear of the cooler, then lift up on the filter and pull on the bottom to release it.

Clean the filter from the inside to the outside (the inside is toward the engine). Never use any liquid detergent. Never use pressurized water as it can damage the filter

TROUBLESHOOTING

cord is plugged in.
Check the power supply.
Press ON/OFF.
There is no air flow.| Damaged engine.
Blockage in the grid or filters.| Contact Technical Service. Clean equipment.
Device isn’t cooling.| Low water level. Damaged water pump. The filter is dirty.
There is too much humidity in the environment.| Fill the water tank. Contact Technical Service. Clean equipment.

You can use the computer as a fan.

Bad smell.| The water or the filter is dirty.| Change water or clean equipment.
Increasing hot sensation in the room.| There is no air renewal and the relative humidity is getting too high.| Make sure that the room is well ventilated and the equipment can constantly receive fresh air.

TECHNICAL SERVICE

In MCONFORT we will be happy to solve any incident that may occur in your device, as well as to solve all the doubts that may arise regarding it.

Please contact us through the following channels:

e-mail sat@mconfort.com

telephone +34 961 536 720

ENVIROMENTAL PROTECTION

Thanks to environmentally friendly disposal, valuable materials can be reused.

1. Unplug the network connection cable from the socket.
2. Cut the network connection cable.
3. Dispose of the device in accordance with environmental regulations.

This appliance is marked with the symbol of compliance with the European Directive 2012/19 /EU on used electrical and electronic equipment (Waste electrical and electronic equipment WEEE). The directive provides the general framework valid throughout the European Union for the removal and reuse of waste electrical and electronic equipment.

PRODUCT WARRANTY

Warranty period:

1. The guarantee applies to the product lines of Evaporative Coolers, Humidifiers, Heaters, Heating Mats supplied under the MCONFORT brand.
2. The warranty period is 2 years, counted from the date of sale.
3. MCONFORT will provide technical assistance at your convenience at the customer’s home, will pick up the equipment to repair it at its facilities or will indicate to the customer the closest TAS where to deliver the equipment for repair.

Requirements for the validity of the guarantee:

1. This guarantee applies only in the Spanish national territory.
2. The equipment must have been used in accordance with the instructions detailed in the user manual.
3. Only the MCONFORT authorized technical service can cover the guarantee.
4. The document that validates the guarantee and that in turn indicates the beginning of it will be the PURCHASE INVOICE.

Warranty coverage:

1. This guarantee does not affect the rights available to the user in accordance with the provisions of RDL 1/2007.
2. In accordance with title V of RDL 1/2007, the user shall have the right to demand the repair and/or replacement of the product from the seller, and/or the producer in the cases determined by law.
3. During the time that the equipment repair lasts, no amount will be paid for damages for the time the equipment has been out of service.
4. We are not responsible for any damage that the equipment may cause to external elements.

Warranty Exclusions:

1. Failure to comply with any of the aforementioned requirements.
2. When the use that has been given to the equipment was not exclusively domestic.
3. The guarantee does not cover accessories or complements added to the equipment.
4. Demonstrations or start-up of equipment.
5. If the failure is caused by fire, flood, meteorological agents, shock or application of inadequate electrical supply.
6. Damage due to mistreatment, including transport damage, which must be claimed from the transport company. It is advisable to inspect the packages received in the presence of the transport company’s personnel, before signing the delivery note in accordance with receipt.
7. Breakdowns caused by physical breakage in casings or plastics.
8. The use of non-original MCONFORT spare parts.
9. Breakdowns caused by misuse.
10. Equipment that does not have the manufacturing serial number, or that has been altered or erased.
11.  When the equipment has been manipulated or repaired by personnel outside or not authorized by MCONFORT.
12. Equipment maintenance and cleaning work
13. Breakdowns caused by wear or normal use of the equipment, such as blockage of filters or drains.

CUSTOMER SUPPORT

sat@mconfort.com
+34 961 536 720
C/ Alcalaten nº 16, Polígono Industrial La Cova.
46940 – Manises, Valencia. SPAIN

mconfort.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>