endeavour ET1540A Vibration Damper Tool Installation Guide
- June 12, 2024
- endeavour
Table of Contents
ET1540A
BMW (N47/N57) VIBRATOR DAMPER LOCKING
REMOVAL AND INSTALLATION TOOL KIT
Installation Guide
ET1540A Vibration Damper Tool
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY.
※ Warning! Ensure Health and Safety, Local authority and general work
shop practice regulations are adhered to when using tools.
※ DO NOT use tool if damaged.
※ Maintain tool in good and clean condition for best and safest performance.
※ WARNING! The warnings, caution and instructions referred to in this
manual cannot cover all possible conditions and situations that may occur. It
must be understand that common sense and caution are factors which cannot be
built into this product ,but must be applied by the operator.
| No. | Description | Size | OEM no. |
|---|---|---|---|
| 1 | Pulley fixed seat | L295xW95xH20 | 117 221 |
| 2 | Pulley fixed Hose 1 | D:Ø25×58 | 117 222 |
| 3 | Pulley fixed Screw1 | M8xP1.25x67L | 117 223 |
| 4 | Pulley fixed Hose2 | D:Ø25×54.5 | 117 222 |
| 5 | Pulley fixed Screw2 | M10xP1.5x65L | 117 223 |
| 6 | Remover Socket | 116 480 |
Necessary preliminary work
※ Remove acoustic cover
※ Remove acoustic cover at front for belt drive, only F10,F11.
※ Remove drive belt for alternator.
Screw A1540-1 with special tool A1540-5 into receptacle of the guide pulley.
Note:
Use A1540-1 to turn the vibration damper in the direction of travel until the
A1540-6 audibly clicks into place on the vibration damper.
Secure A1540-1 vibration damper (A).
Loosen bolts (A) on the vibration absorber (B).
Installation note:
Replace radial shaft seal at front.
Installation note:
Position vibration damper as illustrated when refitting.
Installation note:
Secure the special tool A1540-1 again in the area of the vibration damper to
tighten the screws. Tighten screws crosswise.
Loose bolts (A) on vibration damper (B).
Remove special tool A1540-1 in the area of the vibration damper (A).
Remove vibration damper.