IRONSTAMP A-TS01E Tire Pressure Sensor User Manual
- June 12, 2024
- IRONSTAMP
Table of Contents
IRONSTAMP A-TS01E Tire Pressure Sensor User Manual
No: A-TS01E
Statement: There is a lithium battery in the sensor. The sensor send the
signal by radio signal, pls make sure the sensor is suit for your car.
The sensor works in the Bluetooth band. Bluetooth band:2.4G
Pls make sure your replaced sensor OE No. is one of them:1472547/1472547G/1490701-01-C/1490701-01-B/1490700-00-B. If not, pls contact your seller to confirm the OE No.
1. For tire pressure sensor installation, we recommend user to go to tire repair shop or other experienced shop to change the sensor.
2. After changing, mandatory requirement that the tire pressure should be set
at the required value like 280KPa .
Drive for 10min, tire pressure alarm lamp will disappear. If not, pls contact
with your seller for help.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
The antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be
co‐located for operating in conjunction with any other antenna or transmitter.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>