ZERO ZERO ROBOTICS HOVERAir X1 Foldable Drone User Guide
- June 12, 2024
- ZERO ZERO ROBOTICS
Table of Contents
HOVERAir X1 Foldable Drone
User Guide
HOVERAir X1 Foldable Drone
- Power & Takeoff Button
- Mode Button
- Status Indicator
- Battery
- Battery Level Indicator
- Gimbal Camera
- Status Indicator
- Motor
- Propeller
- Heat Vents
- Downward Vision System
- Prop Guard
Step 1 Download App
Scan the QR code below to download and install Hover X1 App.
“This guide is subject to change without prior notice. Please visit our
official website for user manual and other latest information
Step 2 Charge the battery
- Before you use HoverAir X1 for the first time, be sure to charge it.
Connect the USB cable and USB power source. When battery is being charged, LEDs will blink.
When the battery is fully charged, LEDs will be always-on or always-off
Step 3 Power on
- Press and hold power button for 2 seconds until the voice prompt is heard, and the status indicator will light on in green.
Wait for about 7 seconds, and HoverAir X1 will power on.
Step 4 Mode Selection and Takeoff
- Open up the HoverAir X1 as shown below and hold it flat in your palm.
- Short press the mode button (behind the power button) to select the flight mode of your choice. You can long press the mode button to toggle parameters for each flight mode.
- Short press the power button to take off. Once the propellers have started spinning, remove your hand from under the device.
Step 5 Palm Landing
- Grab the HoverAir X1 mid-flight and press the power button or flip it upside down 180 degrees to stop the propellers
propellers will stop spinning - At the end of the flight or during continuous flight modes, place your hand 20cm below the device and it will automatically land in your hand and the propellers will stop spinning
- Caution
DO NOT stick fingers or anything else into the propeller area. Please refer to the safety instruction manual and disclaimer online for more information.
Step 6 Connecting to the app
- Open the Hover X1 App and enjoy flying HoverAir X1- Make sure your mobile device Bluetooth and WiFi are on. Connecting to the device is managed entirely from the app. there is no need to connect to your Hover via your mobile device settings.
- Open the Hover X1 app and select Hover-> “Click to activate/connect”.
- You may be prompted to allow the app to access Bluetooth.
- Now you can use the app to change flight mode settings
- To download your media, select the “Album” ) icon. You will be prompted to connect to your Hover over WiFi
©2022 ZeroZeroTech – All Rights Reserved
V202307
2Z-H1-001
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>