MONTANA FIRE PITS VENTURE Series Steel Fire Table User Guide
- June 12, 2024
- Montana Fire Pits
Table of Contents
Warning – fire pit sides may become very hot after use. Allow 20-30 minutes of cooling before touching the sides
Quick Setup Guide
IMPORTANT: Before connecting the fuel, it’s necessary to thread the flexible hose to the plate and also to the coupling inside the fire pit. We do not make this connection for you in case it would work free during the shipping process. We have already added tape/sealant to the threads for you. Use a wrench to create a secure connection. If you are unfamiliar with gas connections, consult a plumber.
-
Connect the hose to the Fire Table
• Pull back the brass sleeve, called the quick connect
• Push the end onto the fuel connection on the side of the fire pit
• Release the sleeve and push/maneuver the end until the sleeve returns to its original position, indicating a solid connection
• Turn the gas lever to the OFF position
-
Connect the hose to the propane tank
• Make sure the tank nozzle is shut off
• Thread the regulator into the tank nozzle
• Internal regulators must be turned counter-clockwise (left) in order to tighten -
Light it up
• Ensure the pressure adjuster is closed (turn clockwise as indicated by the C)
• Open the tank nozzle to fully open
• Now open the pressure adjuster 1/2 turn towards the O (left)
• Have your lighter ready and near the burner
• Slowly turn the gas lever at the other end of the hose in order to get fuel flowing
• Use the lighter to light the burner
• Fully open the gas lever and slowly turn the pressure adjuster to set the flame to your desired max flame height
• You can now leave the tank and pressure adjuster where they are and use the gas lever to turn flame off and on
• Hint: Running the pressure too high may cause whistling.
Reduce the pressure adjuster to avoid.
Slowly open gas lever when lighting, close to turn off fire.
Close pressure adjuster before opening tank nozzle.
MONTANAFIREPITS.COM
( 833 ) 228 – 5244