Light Efficient Design LED-7330-XXK-G2 LED PL Lamp Installation Guide

June 12, 2024
Light Efficient Design

PIN-BASED
TYPE A 4-PIN PL INSTALLATION GUIDE
(TYPE A)
MODEL NUMBERS: LED-7330-XXK-G2, LED-7334-XXK-G2

WARNING

These instructions apply to the LED-7330-XXK-G2 and LED-7334-XXK-G2 PL lamps.
Prior to installation, please read the entire installation instructions.
DANGER – Risk of Electric shock. Disconnect power to the luminaire at the source before installation.
WARNING – Risk of Fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician. Installation should be performed by a qualified electrician in accordance with the National Electrical Code and relevant local code.
WARNING – Risk of fire or electrical shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating does not exceed the input rating of the luminaire.
WARNING – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
CAUTION – If the lamp or luminaire exhibits undesirable operation, immediately turn off the power, remove the lamp and contact the manufacturer.
This device is not intended for use with Emergency Exits Suitable for use in damp locations. Do not use where exposed to water.
Suitable for use with compatible electronic ballast. Please see list below.
Suitable for horizontal installation in open, semi-enclosed or recessed fixtures.
Not for use in fully enclosed fixtures.

WARRANTY

These Light Efficient Design LED PL Lamp retrofits are covered by a 5 year limited warranty.
Please see web site www.led-llc.com for more information.

INSTALLATION REQUIREMENTS

PART #| BALLAST COMPATIBILITY*| BASE| ENVIRONMENT| ACCEPTABLE FIXTURES| MINIMUM FIXTURE
DIMENSIONS
---|---|---|---|---|---
LED-7330-XXK-G2| SEE TABLE ON PAGE 2| G24q/GX24q| DAMP & DRY
LOCATIONS| INDOOR – OPEN FIXTURE OUTDOOR – RECESSED| 3.5” X 7.0”
LED-7334-XXK-G2| SEE TABLE ON PAGE 2| G24q/GX24q| DAMP & DRY
LOCATIONS| INDOOR – OPEN FIXTURE| 3.5” X 7.0”

CONTENTS
– 1 pc LED Retrofit Lamp
– 1 pc Re-Lamping Label
– 1 pc Installation Instructions

INSTALLATION INSTRUCTIONS

  1. Turn off power to the luminaire at switch and circuit breaker.

  2. Allow luminaire to cool and remove lamps

  3. Ensure that the luminaire, ballast and electrical input meet the requirements listed above, and are in good condition. Ensure that luminare is open. Do not install in fully enclosed fixture.

  4. Confirm that the ballast is compatible based on the ballast compatibility list shown below.

  5. Insert the lamp into the lamp holder.

  6. Apply the silver adhesive label to the inside of the luminaire where it will be visible during re-lamping.
    6. For LED-7334-XXK-G2 only, rotate the light head so that the led panel is projecting the light in the proper direction.

  7. Turn on the power to the fixture and verify proper operation.
    WIRING DIAGRAM AND BALLAST COMPATIBILITY LIST

| | | | | |
---|---|---|---|---|---|---
| 1-Lamp| 2-Lamp
Brand| Model| Volt| 120V| 277V| 120V| 277V
GE| GEC218-MVPS-3W| 120-277V| V| V| V| V
GE| GEC226-MVPS-3W| 120-277V| V| V| V| V
PHILIPS/ADVANCE| ICF-2518-H1-LD| 120-277V| V| V| V| V
PHILIPS/ADVANCE| ICF-2526-H1-LD| 120-277V| V| V| V| V
PHILIPS/ADVANCE| ICF-2542-M2-LD| 120-277V| V| V| V| V
PHILIPS/ADVANCE| REZ-2Q26-M2-LD| 120V| V| V| V| V
Universal/Triad| C218UNVSE| 120-277V| V| V| V| V
Universal/Triad| C213UNVME| 120-277V| V| V| V| V
Universal/Triad| C2642UNVME| 120-277V| V| V| V| V
OSRAM/SYLVANIA| 2*26CF/UNV DM| 120-277V| x| x| x| x
FULHAM| WH2-277-L| 120-277V| x| x| x| x
HATCH| HC213P5/UV/D| 120-277V| x| x| x| x
HATCH| HC218PS/UV/WJ| 120-277V| x| x| x| x
HATCH| HC218PS/UV/D| 120-277V| x| x| x| x
KEYSTONE| KTEB-226-UV-PS-DW| 120-277V| x| x| x| x
PONY| NPY-120-126CFL| 120V| x| x| x| x
| | √| Compatible| |
| | x| Not Compatible| |

LIGHT EFFICIENT DESIGN HEADQUARTERS 188 S. Northwest Highway • Cary, IL 60013
INNOVATION & MANUFACTURING CENTER 30 Log Bridge Road, Building 200 • Middleton, MA 01949
847.380.3540 • led-llc.com
07.29.22 Information is subject to change without notice.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals