JBC Tools H0511 Tool Holder for CDN Station Instruction Manual
- June 12, 2024
- JBC Tools
Table of Contents
www.jbtools.com
INSTRUCTION MANUAL
H0511
Tool Holder for CDN Station
This manual corresponds to the following reference:
0030511
Packing List
The following items are included:
Tool Holder for CDN ………. 1 unit Manual ……………………………. 1 unit
Ref. 0031092
Features
H0511 Tool Holder works with CDN Compact Stations and supports NT115 Nano
Handles. It detects whether the tool is inserted in it and activates Sleep and
Hibernation Modes.
Replacing the Tool Holder
First disassemble the tool holder by loosening the set screw (1).
Remove the tool holder (2) and replace it with the new one.
Insert the new tool holder bar into the slot on the station (3) in
vertical position and as far as it will go. 
Note: The flat
area on the tool holder bar must align with the threaded hole (4) on the back
of the station.
Finally, tighten the set screw to fix the
tool holder.
Specifications
H0511
Tool Holder for CDN Station
Ref.: 0030511
– Total Net Weight: 20.66 g / 0.05 lb
– Package Dimensions / Weight: 96 x 55 x 46 mm / 38 g (L x W x H) 3.78 x 2.17
x 1.81 in / 0.08 lb Complies with CE standards.
Warranty
JBC’s 2 year warranty covers this equipment against all manufacturing defects,
including the replacement of defective parts and labour.
Warranty does not cover product wear or misuse.
In order for the warranty to be valid, equipment must be returned, postage
paid, to the dealer where it was purchased.
**** This product should not be thrown in the garbage.
In accordance with the European directive 2012/19/EU, electronic equipment at
the end of its life must be collected and returned to an authorized recycling
facility.
