Raita EV 200 KU Toilet User Manual

June 4, 2024
Raita

Raita EV 200 KU Toilet User Manual

EV 200 KU installation, care, maintenance

Thank you for choosing the EV 200 KUBioToilet. Read these instructions before installation. If you have any further questions that are not answered in these instructions, call +358 400-912111 or email helpdesk@raita.com

INSTALLATION

Seat, connecting pipe and trolley (van)
A tank-shaped opening is sawn into the floor and back wall. If necessary, use a level under the tank, a suitable seat height is 43-50 cm. The trolley’s space requirements are – 92 cm in height and 80 with x 60 cm deep. The space requirement for the toilet space is 50 (W) x 70 (W) cm, we recommend a larger toilet space, eg 100 (W) x 100 (W) cm. The trolley is removed through an opening, hatch or door (for emptying). If the toilet is used in winter, insulate the room and (if necessary) install heating (purchased separately – min. +10 degrees C thermostatically controlled). Insulation (eg 50 mm) base, walls, door or door. The liquid pipe is insulated. Connecting pipe (diameter 20 cm – 50 cm, longer are also available) is shortened depending on the installation site.

Ventilation
The ventilation pipe (D110) is led out. The end of the pipe must be 60 cm above the ceiling. The delivery includes coupling part D75 mm> 110 mm (+), and 110 pipe cap (-). Other necessities are purchased separately (straight pipes and any 30-degree angles). We recommend that the replacement air is taken into the toilet from the outside. All air that leaves the room passes through the ventilation. For winter use, we recommend insulating the pipe in cold rooms.

Fluid pipe connection
Connect the liquid pipe (D32) to the tank or drain (0.7 m on delivery, supply air branch and filter and 90-degree angle, extra pipe if required). Excess liquid (installation method; ECO or ECOSEP) is discharged into the drain with washing and rinsing water (7). It can also be led to a separate biofilter and infiltrated to the ground. It can also be collected (5) in a separate container (20 l container included) or in a tank (6). Separated urine (installation method SEP; delivery includes separating seat outlet (D32 +), 1.5 m 32 hoses, and bushing) is collected in a separate container (20 l container is included in delivery or tank (6)). For winter use, we recommend insulation/heating of the liquid pipe in the cold room.

To remove the trolley from under the seat:

  1.  Lift off the top of the seat
  2.  Raise the connection tube
  3.  Lift up the ventilation connection
  4.  Pull the trolley backward
  5. Remove the liquid pipe

MAINTENANCE

General
A properly installed EV 200 KU system may malfunction if the unit is not properly maintained. Lack of maintenance can cause malfunctions and problems with the composting process. As a result, the device may contaminate the environment and groundwater, causing serious damage to health, and spreading diseases and unpleasant odors. Maintain EV 200 KUaccording to the instructions and EV 200 KUworks odorless, hygienic and environmentally friendly.

Toilet waste
Toilet waste consists of feces, urine and toilet paper. It contains organic and inorganic substances, solids, microorganisms, various bacteria and viruses. Leading untreated toilet waste in nature leads to environmental and health risks. The load produced by a person’s feces and urine corresponds to 90% of the daily nitrogen load for all wastewater produced by a person, 80% of the phosphorus load and 40% of the organic load. When toilet waste is treated in EV 200 KU , the strictest sewer cleaning requirements are easily met.

 EV 200 KU ‘S MAINTENANCE

  •  Start EV 200 KU correctly during commissioning (after emptying).
  •  Add Drymix to EV 200 KU regularly.
  •  Level the compost in the container if necessary.
  •  Replace/empty the composting van (trolley) if necessary

In addition, make sure that NO substances that interfere with composting, such as medicines, tobacco molds, bandages, diapers, condoms, solvents, oil, paint or other hazardous waste, are NOT loaded.
ONLY for feces, urine, toilets, paper, compost substance (litter) and biodegradable household waste (biowaste). Stir the compost (after 50-100 uses).
EV 200 KUbiotoilet can be equipped with two or more trolleys – at the same time when the trolley under the seat is filled – the composting continues in the other trolley.

When it’s time to change the trolley – you empty the one that is already composted – and replace the trolley with the empty one. The trolley for composting is closed with lid with ventilation.

In the emptied trolley – add a 1-2 cm layer of Drymix compost litter to start the process.

After using the toilet, add Drymix approx. 1 dl/use.

Use of EV 200 KU – general about compost litter
EV 200 KU uses compost litter to remove moisture, achieve the right carbon- nitrogen ratio and ensure airiness in the composting. We recommend using Drymix peat-pellet (wood chip) mixture. Peat-wood chip mixture and other custom-made substances can also be used in EV 200 KU . If desired, dried tree leaves, sawdust, chips, etc. can be used. When using other materials, care and capacity may vary from normal. Measures before starting to use (even after emptying) Place 1-2 cm of Drymix on the bottom of the composting chamber ECO, ECO-SEP (1). Fill in the biofilter compartment ECO-SEP (2).

If you use a compost litter other than Drymix make sure that a sufficiently coarse material enters the bottom to prevent the litter from leaking into the liquid compartment. In the SEP model, you can use a biodegradable plastic bag (3) in the lower container. SEP Models with inner bags can also be used without composting litter.

Troubleshooting:

Problem
Bad smell in the toilet room:

Reason:
The air ventilation does not work.

Remedy:
Check the humidity and the ventilation pipe. Increase the ventilation so that the toilet room always has a little negative pressure Bad smell near the compost van:

Reason:
The air circulation does not work, the compost is too moist, the waste is not covered.

Remedy:
Check the humidity and the ventilation pipe add compost litter to cover the waste Flies in the compost

Reason:
No ventilation hat, insufficient mixture, not enough litter in the compost

Remedy:
Install a ventilation hat and use enough litter, use pesticide daily for two weeks (environmentally friendly pesticide) or empty the container and start over. The compost smells when emptied

Remedy:
There is not enough litter in the compost, or the capacity is not enough to compost the amount of waste (composting time is too short)

Remedy:
Add more compost litter, get an extra compost cart to increase capacity

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals