PLEG OEMPRO TTL06-610TW Large Screen Telescopic Height-Adjustable Steel TV Instruction Manual

PLEG OEMPRO TTL06-610TW Large Screen Telescopic Height-Adjustable Steel TV Instruction Manual

Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your local distributor for assistance.

CAUTION

• Use with products heavier than the rated weights indicated may result in instability causing possible injury.
• Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
• Safety gear and proper tools must be used. This product should only be installed by professionals.
• Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
• Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
• This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
• This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.

Requirement for Installation

Component Checklist

• base (x1)
  

• wheel caster (x4)

• universal plate (x1)
  

• top cover (x2)

• cable cover (x2)

• DVD shelf (x1)

• left column (x1)
  

• right column (x1)
  

• left adapter bracket (x1)
  

• right adapter bracket (x1)
  

• camera ihew (x1)
  

• cross bar (x1)

• support bar (x1)

• butterfly nut (x2)

• butterfly nut (x4)

• M8x30 (x8)

• M6x14 (x2)

• M6x25 (x4)

• M6x14 (x6)

• M6x8 (x4)

• M8x65 (x4)

• D8 washer (x4)

• D6 washer (x2)

• 5mm Allen key

• wrench

IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of purchase for a replacement.

• M5x14 (x4)

• M6x14 (x4)

• M6x30 (x4)

• M8x30 (x4)

• M8x50 (x4)

• washer (x4)

• small spacer (x8)

• big spacer (x8)

Installing the Wheel Caster

Note: Each caster can be adjusted independently for fine tuning. Slightly turn the nut to lower or raise the base.

Attaching the Columns to the Base

Pull the pin outwards and pull the inner column upwards at the same time, until the inner column is pulled to the desired height then release the pin to secure.

Attach the columns to the base using the screws.

Installing the Cross Bar

Attach the cross bar to the columns with the appropriate screws. Tighten all screws using a proper Phillips. screwdriver.

When the cross bar installation is completed, tighten the bottom screws using an Allen key.

Press the metal tab to lock the caster.

Installing the Cable Covers

Installing the Universal Plate

Attach the universal plate to the columns with the appropriate screws, washers and butterfly nuts. Tighten all screws and butterfly nuts.

Installing the Adapter Brackets

6a For Flat Back Screens

For Screens with Irregular Back

Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.

• Position the adapter brackets as close as possible to the center of the display.
• Screw the adapter brackets onto the display.

ATighten all screws but do not over tighten.

Hooking the Display onto the Universal Plate

• Hook the display onto the universal plate.
• Tighten the bottom screws to secure them.

IMPORTANT: Make sure the display is mounted correctly and the screws are tightened safely before releasing the display.

Installing the Camera Shelf

Installing the DVD Shelf

Install the support bar to the columns at the desired position and secure using the appropriate screws.

Attach the DVD shelf to the support bar with the ~ appropriate screws and butterfly nuts. Tighten all screws and butterfly nuts to secure.

Cable Management

Route the cables through the cable covers.

Adjustment

• It is recommended to adjust the columns to the desired height before installing the display.
• If you want to adjust the columns height after finishing the display installation. Please remove the DVD shelf , then adjust the columns to the desired height.

Maintenance

• Check if the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>