MET ONE INSTRUMENTS SWIFT 25.0 Flow Meter User Guide
- June 13, 2024
- Met One Instruments
Table of Contents
MET ONE INSTRUMENTS SWIFT 25.0 Flow Meter
Product Information
The Swift 25.0 Flow Meter is a device designed to measure flow, temperature, and pressure. It requires the installation of a Silicon Labs CP210x driver before connecting it to a computer. The unit can be charged using the included USB cable. The Swift Setup Software allows users to change the units of flow, temperature, and pressure. The Swift 25.0 Manual and Swift Utility Software can be downloaded from the provided web link.
Product Usage Instructions
- Install the Silicon Labs CP210x driver on your computer before connecting the Swift 25.0 flow meter.
- Connect the Swift 25.0 flow meter to your computer using the included USB cable.
- Charge the unit fully by connecting it to a power source using the USB cable.
- Once charged, disconnect the USB cable from the unit.
- To change the flow, temperature, or pressure units, use the Swift Setup Software.
- Download the Swift 25.0 Manual and Swift Utility Software from the provided web link for further instructions on using the product.
Note: A Silicon Labs CP210x driver must be installed before connecting the Swift 25.0 flow meter to a computer. USB Driver web link: https://metone.com/software/. Before operating the Swift 25.0 for the first time, it is recommended that the unit be fully charged using the included USB cable.
- Energize the unit Note: The Swift 25.0 performs a zero flow calibration (tare) each time the unit is turned on. To prevent flow measurement inaccuracies, ensure no air flow is passing through the flow meter while energizing the unit.
- The Swift 25.0 is ready to begin sampling once the operate screen is displayed after a short boot up. Readings are updated on the display once per second. A battery level indicator is located at the top-left area of the display.
Flow, temperature, and pressure units can be changed using the Swift Setup
Software.
Visit this Web Link to Download the Swift 25.0 Manual and Swift Utility
Software:https://metone.com/products/swift-25-0/.
Technical Support
Technical Service representatives are available during normal business hours of 7:00 a.m. to 4:00 p.m. Pacific Time, Monday through Friday. In addition, technical information and service bulletins are available from our website. Please contact us at the phone number or email address below to obtain a Return Authorization (RA) number before sending any equipment back to the factory for calibration or repair.
CONTACT
- Phone: 541-471-7111 Fax: 541-471-7116
- E-Mail: service@metone.com.
- Web: www.metone.com.
- Met One Instruments, Inc.
- 1600 NW Washington Blvd
- Grants Pass, OR 97526
- Swift 25.0-9801 Rev A
References
- Met One - Precision Air Quality Monitoring Instruments
- Met One - Precision Air Quality Monitoring Instruments
- Swift 25.0 Flow Calibrator - Met One Instruments
- Software - Met One Instruments