TURNIGY SK8 ELectric Skateboard ESC User Manual
- June 4, 2024
- TURNIGY
Table of Contents
ELECTRIC SKATEBOARD ESC MANUAL
DECLARATION
Thank you for purchasing the 5K8 Electric Skateboard ESC! Brushless power system can be very dangerous. Any improper use may cause personal injury and damage to the product and related devices. We strongly recommend reading through this user manual before use.
Because we have no control over use, installation, or maintenance of this product, no liability may be assumed for any damages or losses resulting from the use of the product. We do not assume responsibility for any losses caused by unauthorized modifications to our product.
FEATURES
– STM32F4, 32-bit ARM MCU.
– High quality MOSFET and capacitor.
– Sensored and Sensor less operation.
– Sensored and Sensor less FOC with auto-detection of all motor parameters.
-Current and voltage measurement on all phases.
– Regenerative braking.
– GUI with lots of configuration parameters.
– Adaptive PWM frequency to get as good an ADC measurement as possible.
– RPM based phase advance (Or timing/field weakening).
-Good start-up torque in the Sensor less mode.
– Duty-cycle control, speed control or current control.
– Seamless 4-quadrant operation.
-Consumed and regenerated amp-hour and watt-hour counting.
-Optional PPM signal output ( ESC V6 & 2inl ESC only).
– Adjustable protections as follows:
- Low/high input voltage
- High motor/input current
- High regenerative braking current (Separate limits for the motor and the input)
- Rapidly duty-cycle changes (Ramping)
- High RPM (Separate limits for each direction)
SPECIFICATION
SPECIFICATIONS/Model
| Single ESC| ESC V6|
2in 1 ESC
---|---|---|---
Hardware:
| Based on V4.12| Based on V6|
Based on V4.12
LiPo:|
3-12S
| 3-12S|
3-12S
Continuous current:|
60A
| 80A|
60A/60A
Peak current:|
120A
| 150A|
120A/120A
BEC:|
5V/1.5A
| 5V/1.5A|
5V/1.5A
Dimension(mm):|
725023
| 808020|
1176624
Weight:|
127g
| 114g|
200g
Note:| Continuous current values to depend on the temperature and the air circulation of the device.
CONNECTION DIAGRAM
HOW TO USE
5K8 tool on-line manual: Refer to product listing page at www.hobbyking.com On-line manual indudes:
- Updating the firmware
- Motor Wizard FOC
- Input Wizard for PPM remote
- Input Wizard for NRF remote
- Additional setting: Throttle curves, ERPM limits, safety features etc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>