Emlid Reach RS2+ To Work As A Base For Drone RTK Connection User Guide
- June 13, 2024
- Emlid
Table of Contents
Setup Reach RS2+ to work as a base for drone RTK connection
without external network connections
Reach RS2+ To Work As A Base For Drone RTK Connection
- Download Reachview 3 app and follow :
https://docs.emlid.com/reachrs2/before-you-start/first-setup
3 Turn on the Receivers hot spot – which disconnects it from the regular wifi network and turns it into a local wifi transmitter that you can connect your DJI RC to (this will not have an Internet connection) It is purely the radio connection to transfer the Receiver gps corrections to the RC controller. The RC controller can not be more than a few meters from the receiver to receive the corrections
enter settings for the receiver after hot spot is active and phone is
connected directly see screen shots 13-26 on page 5-6
Place your Reach on the tripod and provide it with a clear sky view over your
know point.
You will need the measured height for entering in the step in screen shot 8
*Critical info: – longitude must be entered in the Reachview app in East
Longitude most surveyors will provide Longitude in West Longitude.
Ask surveyor for East Longitude. Click here to convert West longitude to East
if required.
Lat and Long must be entered in decimal degrees in the Reachview 3 app Click
here to convert degrees minutes seconds to decimal degrees.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>