better bathrooms 1504954 Ashford 800mm Floor-standing Vanity Unit User Manual
- June 4, 2024
- Better Bathrooms
Table of Contents
better bathrooms 1504954 Ashford 800mm Floor-standing Vanity Unit
Thank you for choosing Better Bathrooms.
Please read this manual before installing your product and keep for future
reference.
BATHROOM FURNITURE CUSTOMER CARE GUIDE
Please note that although these units have been designed to give years of pleasure and satisfaction, you will help maintain the original beauty of your bathroom by following these guide lines.
Melamine, Vinyl and Foil Wrapped Doors
Occasional marks, can in most cases, be removed with a soft damp cloth. More
persistent marks can be removed using a non silicone based furniture cleaner.
Hot soapy water should be avoided. Once the mark is removed, the area should
be wiped over with a damp cloth to remove any excess and dried with a soft
clean cloth. On no account should solvent or an abrasive cleaner be used as
permanent damage to the finish could take place.
High Gloss Doors
Use a cleaning product not containing aggressive substances like acetone,
alcohol, bleach … as those components could seriously damage the surface of
the door. The best would be to use a soft cotton or micro fibre cloth with
only water and soft soap (containing a maximum 1% of liquid soap) Carcase
Components
Do not use polish on any surfaces. A damp cloth with soapy water will clean off most marks or spills. Bleaches, scouring pads and multi-surface cleaners should not be used.
Drawers, Runners, Door Hinges
These should be wiped out with a damp soapy cloth and wiped dry with a soft
cloth as necessary. The roller runners and hinges are lubricated and should
not be cleaned with a degreasing agent as this will affect the action of the
moving parts. Never lean on partially or fully opened doors and drawers in
order to gain access to the units. The hinges are specified to adequately
support the weight of the door, plus small additional weights such as wire
accessories. It is advised that once the bathroom has been installed you
should check every six months that all screws on the hinges are tight.
Worktops
Although the worktop is hard wearing, sharp objects will scratch and excessive
heat will scorch the surface. Care should be taken not to drop any heavy
objects onto the worktop as the surface may crack.
For cleaning, a damp soapy cloth will clean off most spills. Bleaches,
scouring pads and multi-surface cleaners should not be used. Corrosive liquids
and make-up should be wiped off immeadiately. On no account should any
spillage, even water, be allowed to lie on the surface.
Temperature and Humidity
Avoid excessive change in temperature and humidity. Always try to ensure
adequate ventilation.
General care, spillages and splashes
On no account should any spillages or splashes, even water, be allowed to lie
on any surface.
All spillages and splashes should be wiped dry, failure to do so may shorten
the life expectancy of the product and invalidate any guarantees.
Congratulations on your purchase
And welcome to our growing gang of savvy shoppers
We’re on a mission to bring you extraordinary bathroom products, for less.
From modern to traditional style ceramics, plus the gorgeous fixtures,
fittings and furniture to match. So, you can fall in love with your space
every single day.
As one of the UK’s largest independent bathroom stores, we’ve received
countless awards; including the National Business Awards UK, the Digital
Entrepreneur Awards and being placed on The Sunday Times Fast Track 100.
We hope your new product goes above and beyond your expectations. However,
should any problems occur, please:
- log in to your account and contact our customer services team via your self-serve portal – betterbathrooms.com/CustomerAccount/Login
- contact us via betterbathrooms.com/content/contact-us
Important information
- Please read these instructions thoroughly and retain for future reference
- Maximum weight limit: 80kg (400-600mm cabinet)
100kg (600-800mm cabinet)
120kg (1200mm cabinet)
120kg (tall cabinet)
50kg(shelf only)
Please spend 5 minutes reading this section before commencing with the installation of your new furniture.
- Should any of your items have a defect, please do NOT install as returns will not be accepted once fitted.
- We advise that you use a qualified person to install your units, as any issues relating to poor fitting will not be accepted by the supplier.
- You have purchased a handmade and in some cases hand painted product. Therefore, you may see some slight imperfections which the supplier may deem as acceptable.
- This product is water resistant but NOT waterproof. On no account should any spillages or splashes, even water, be allowed to lie on any surface. All spillages and splashes should be wiped dry, failure to do so may shorten the life expectancy of the product and invalidate any guarantees.
- Please avoid direct sunlight as this will cause the painted surfaces to discolor.
- Due to motion in transit, the cabinet doors and drawers may need to be adjusted after installation.
- Floor Standing units must be fitted back to the wall through the backrail using suitable fixings. (not supplied)
- Basin units should be fitted as above. The basin should also be secured where applicable using Fischer bolts through the fixing points under the basin. (not supplied) Note that not all basins have this facility.
- Wall Hung units must be secured back to the wall using the wall hanging brackets or suitable wall fixings when not supplied. Additional support is recommended using ‘L’brackets. (not supplied)
- When fixing to a stud or panelled wall, appropriate frame work should be installed to support the basins and units.
- Where units or worktops have to be cut-out for services, all raw edges MUST be sealed against water ingress.
Hinge Adjustment
Drawers Remove/Install
To Remove the Drawer: Follow step ‘A’ and remove the fastener then follow step
‘B’.
To Install the Drawer: Follow step ‘B’ and then follow step ‘A’ to lock the
fastener.
Drawer position: If drawer position needs altering follow step ‘C’ to adjust
the screw.
Tools required for installations
The doors/drawers are provided undrilled as the product can be fitted with different length handles, once the door/drawer orientation has been selected, measure the center to center hole dimension of the handle to be fitted, mark this on the outside of the door (double check this as drilled doors cannot be returned) place a block of wood as indicated below on the inside of the door, along with masking tape on the outside where the hole is to be made to prevent chipping and drill through from the front of the door using a 5mm drill bit, do not force the drill and, once drilled apply a small amount of clear silicone in the holes to seal the door”
Note: For safety reasons Unit must be secured to the wall using suitable fixings (pre-drilled holes provide in back panel of unit)Please note-wall fixings are not supplied These can be purchased from a local DIY store
When fitting a basin to a unit, a bead of silicone should be applied to the top edge of the basin unit to seal between the basin and unit.
Wall hung unit installation.( fixings in box)
Please measure the L distance between each brackets on unit. and H ( height as customers request. The standard height is 850mm (including basin height) from floor to wash basin
Mirror cabinet and Storage unit. ( plug screws with chrome covers in box)
Please measure the L&H distance between each pre-drilled holes on products.and
fixing them as below steps.the distance will be 300-400 the mirror cabinet to
basin as below . the distance from floor to bottom of storage as customer
requests.
- Clean with a soft cloth & warm soapy water only
- Do not use abrasive cleaning agents
- Dry unit with a cloth after use
For more information
visit betterbathrooms.com
email
customerservices@buyitdirect.co.uk
call 0330 390 3062
write to Trident Business Park,Neptune Way,Huddersfield,HD2 1UA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>