testo 570s Digital Manifold with 4-Way Valve Block Instruction Manual

**testo 570s Digital Manifold with 4-Way Valve Block Instruction Manual

**

Product Instruction

| | | | |
---|---|---|---|---|---
229 x 112.5 x 71 mm
| | Rechargeable lithium battery integrated 3400 mAh 3 x 1.5 V AA Alkaline| HD/ND: -100 … 6000 kPa / -0.1 … 6 Mpa / -1 … 60 bar (rel) / -14.7 … 870 psi| -50 … +150 °C -58 … +302 °F testo 115i: -40 … +150 °C -40 … +302 °F vaccum: 0 … 20.000 micron| 1250 g (without AA battery)

Approval and Certification

The use of the wireless module is subject to the regulations and stipulations of the respective country of use, and the module may only be used in countries for which a coun- try certification has been granted. The user and every owner has the obligation to adhere to these regulations and prerequisites for use, and acknowledges that the re-sale, export, import etc. in particular in countries without wireless permits, is his responsibility.

The EU Declaration of Conformity can be found on the homepage under the product specific down-loads.
EU countries: Belgium (BE), Bulgaria (BG), Denmark (DK), Germany (DE), Estonia (EE), Finland (FI), France (FR), Greece (GR), Ireland (IE), Italy (IT), Latvia (LV), Lithua- nia (LT), Luxembourg (LU), Malta (MT), Netherlands (NL), Austria (AT), Poland (PL), Portugal (PT), Romania (RO), Sweden (SE), Slovakia (SK), Slovenia (SI), Spain (ES), Czech Republic (CZ), Hungary (HU), United Kingdom (GB), Republic of Cyprus (CY). EFTA countries: Iceland, Liechtenstein, Norway, Swit- zerland
 WEEE Reg. no.: DE 75334352
United Kingdom (GB)|

The UK Declaration of Confor-mity can be found on thehomepage under the productspecific downloads

USA|

FCC ID: WAF-05645701see FCC Warnings

IC Warnings

CAN ICES-003(B)/NMB-003(B):
This Class B digital apparatus complies with Canadian ICES-003.

RSS-Gen & RSS-247 statement:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including inter- ference that may cause undesired operation of the device.

Caution: Radio Frequency Radiation Exposure This device has been tested for compliance with IC SAR values at a typical operating near the body. To ensure that RF exposure levels below the levels tested, use acces-sories with this equipment to maintain a minimum sepa-ration distance of 0mm between the body of the user and the device. These accessories should not contain metallic components. It is possible that the accessories used close to the body that do not meet these requirements are not consistent with the SAR limits and it is advisable to avoid using them

FCC Warnings
Information from the FCC (Federal Communications Commission)

For your own safety
Shielded cables should be used for a composite interface. This is to ensure continued protection against radio fre-quency interference.

FCC warning statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment. Shielded interface cable must be used in order to comply with the emission limits.

Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation

Caution: Radio Frequency Radiation Exposure
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types testo 570s (FCC ID: WAF05645701) has also been tested against this SAR limit. This device was tested for typical body‐worn operations with the back of the handset kept 0mm from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 0mm separation distance between the user‘s body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided.

Co-Location:
This device must not be co-located or operated in conjunction with any other antenna or transmitter.

Tel: 1.888.610.7664
Web: www.calcert.com
E-mail: sales@calcert.com

References

• Calcert

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>