Horticulture Lighting Group HLG Tomahawk Bar Lamp’s Instruction Manual
- June 12, 2024
- Horticulture Lighting Group
Table of Contents
Horticulture Lighting Group HLG Tomahawk Bar Lamp’s
Product Information
The HLG Tomahawk is a lamp designed for lighting purposes. It comes with the following included hardware:
- Qty 1: Allen Wrench
- Qty 2: Locking screws
- Qty 4: Driver Mounting Bolts
Please note that mounting the driver on the HLG Tomahawk is not recommended by HLG as it will void the ETL Certification of the lamp. HLG holds no responsibility for any consequences resulting from mounting the driver.
Product Usage Instructions
- Unfolding and Assembly of the HLG Tomahawk:
- Remove the lamp from the packing box.
- Place the lamp face down on a level surface.
- Locate the PEM set locking holes on the rails of the HLG Tomahawk.
- Using the Allen Wrench, insert the two locking screws into the PEM sets and tighten them completely to secure the lamp in an open position.
- Connecting the M16 Wiring Harness:
- Locate the two M16 quick connect wiring harness ends. One end is attached to the lamp, and the other end is attached to the driver.
- Connect the M16 ends together and tighten the screwing lock to secure the connection.
- Mounting the Driver on the HLG Tomahawk:
- Locate the driver mounting PEM sets inside the rail of the Tomahawk.
- Using a Phillips head screwdriver (not included), insert the four driver mounting bolts into the PEM sets and tighten them to secure the driver.
The Tomahawk Driver DC Extension Cord is available for purchase on the
HLG.com website.
Please refer to the assembly instructions and follow them carefully for proper
usage and installation of the HLG Tomahawk.
Included Hardware:
- Qty 1: Allen Wrench
- Qty 2: Locking screws
- Qty 4: Driver MounA”;(B8$1<
Unfolding and Assembly of the HLG Tomahawk
The HLG Tomahawk is folded within the packing box.
Remove lamp and unfold it face down on a level surface
Locate the PEM set locking holes on the rails of the HLG Tomahawk.
Using the Allen Wrench (1), insert the two locking screws (2) in the PEM sets. Tighten each nut completely to secure the lamp open.
Locate the two M16 quick connect wiring harness ends. One is attached to the lamp and the other is attached to the driver.
Connect the M16 ends together and tighten the screwing lock to secure the connection.
Mounting the Driver on the HLG Tomahawk
Please note: Mounting the driver is not recommended by HLG. This will void the ETL Certification of the lamp. HLG holds no responsibility.
Locate the driver mounting PEM sets inside the rail of the Tomahawk. Align the driver channels with the PEM sets.
Using a Phillips head screwdriver (not included), insert the four driver mounting bolts (3) and tighten to secure the driver.
Tomahawk Driver DC Extension Cord
Available on the HLG.com website
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>