aperta A1ML250 250kg Holding Force Magnetic Lock Instruction Manual

Table of Contents

aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-
product

The latest product manuals and software is available online: https://www.espuk.com/technical_support.

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $1$$

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $2$$

Fold the drill template to 90°
After close the door, put the drill template close to the top side of the door frame
Mark screw positions on the door frame
Drill holes according to your marked positions
Make a combination based on the picture
Knock the pin into the plate gently to avoid the plate moving.
Rubber gasket makes the plate can be adjustable slightly and ensure the lock body and plate can be combined tightly to reach max holding force.
Remove the mounting plate from the lock body.
Fix the plate to the screw position which you marked before.
Fix the lock body to the mounting plate by the Allen key
Open the door to test the holding force. Adjust the gap between the plate and the Magnetic lock surface by tightening the plate or Increasing & decrease the rubber gasket.
Tighten the tamper screw after making sure all installation steps are correct and work well.

L bracket
When the door frame is narrow, an L bracket is needed.

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $15$$

ZL bracket
For the inward opening door, a ZL bracket is needed.

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $16$$

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $17$$

Optional connection method of backflow prevention diode:

$aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $18$$

Connection method of backflow prevention diode:

Connect the negative electrode of the diode with the positive electrode of the lock body
Connect the positive electrode of the diode with the negative electrode of the lock body $aperta-A1ML250-250kg-Holding-Force-Magnetic-Lock-fig- $19$$

Notice

When installing the armature plate, please do not tighten the screws too tightly and allow the rubber gasket to have proper elasticity, so that the armature plate can automatically align itself to the correct position and magnetise with the magnet.
The magnetic lock uses the principle of generating magnetic flux from an energizing coil. Therefore the heating of the magnetic coil is normal and is normal at 45°C (± 10%)
EVBPSBB is sold separately, (optional) diode not included.

Elite Security Products UK, Unit 7 Target Park, Shawbank Road, Lakeside, Redditch, Worcestershire, B98 8YN
Tel: +44(0) 1527 51 51 50
Fax: +44(0) 1527 15 01 43
Email: info@espuk.com.

Registered in England, Company Registration Number: 02769392, VAT Registration: GB614686525.

For more product information please visit www.espuk.com
E&OE – Errors and Omissions Excepted. I22.