URGEEN HiTune X6 Hybrid Active Noise Cancelling Earbuds User Manual
- June 12, 2024
- URGEEN
Table of Contents
URGEEN HiTune X6 Hybrid Active Noise Cancelling Earbuds
What’s in the Box
Fully Charge Before First Use
For first-time use, please peel off the insulation films and charge the
earbuds with the provided USB-C cable.
Wear and Adiust
Adjust the earbud position and nick the right size for the perfect.
Bluetooth Connection
After turned on, earbuds will enter pairing mode: find and connect “UGREEN HiTune X6” on your Bluetooth list.
Fix Bluetooth Pairing or Connection Problems
Open the case (earbuds inside), press & hold the reset button for 10s until
the earbuds blink blue/white alternately for 3 times, and the charging case
blinks white 3 times, indicating a successful resetting.
Music Control
- Volume-: Double-tap L bud
- Previous Track: Triple-tap L bud
- Volume+: Double-tap R bud
- Next Track Triple_tan R bud
Music Control
- Plav/Pause: Single-tap L/R buds
Answer/End a Call
Take/End a Call: Single-tap L/R bud
Noise-Cancellation Control
Cycling through “ANC On/ANC Off”: Press & hold L/R bud.
Voice Assistant
Activating Voice Assistant: Press & hold L/R bud for 2s
Gaming Mode
Music Gaming Mode: Ouadruple-tan on UR bud
Specifications
Important WEEE Information
This symbol on the products) and/or accompanying documents indicate that,
under the new Directive 2012/19/EU on waste electrical and electronic
equipment (WEEE), product(s) used for electrical and electronic equipment
(WEEE) should not be mixed with general household waste. For proper treatment,
recovery, and recycling, please take this product) to designated collection
points where it will be accepted free of charge. Disposing of this product
correctly will help save valuable resources and prevent any potential negative
effects on human health and the environment, which could otherwise arise from
inappropriate waste handling. Please contact your local authority for further
details of your nearest designated collection point. Penalties may be
applicable for incorrect disposal of this waste, in accordance with your
national legislation. For professional users in the European Union If you wish
to discard electrical and electronic equipment (EEE), please contact your
dealer or supplier for further information. For disposal in countries outside
of the European
Union
This symbol is only valid in the European Union (EU). If you wish to discard
this product please contact your local authorities or dealers and ask for the
correct method of disposal.
Warranty Information
A limited 2-year warranty applies to all UGREEN products purchased from
UGREEN’s official store or authorized sellers. Please feel free to contact us
if you run into any problems. Learn more about the EU Declaration of
Conformity:
https://www.ugreen.com/download/
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference; (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>