ABBA LIGHTING UNB08 Brass Well Light Installation Guide
- June 12, 2024
- ABBA LIGHTING
Table of Contents
ABBA LIGHTING UNB08 Brass Well Light
12V LED UNDERGROUND LIGHT
Rated Voltage 12V AC/DC
- Thank you for purchasing this quality product. To ensure correct function and safety, please read and follow all instructions carefully before assembly, installation, and use of this product. Please keep instructions for future reference.
- NOTE: This installation instruction applies to the 12V side of the luminaire only.
- This luminaire is 12V extra-low voltage and can be DIY.
- Do not plug this luminaire directly Into 240V.
Warranty
- This luminaire is covered by a 5-year warranty. The warranty is from the date of purchase, not the date of installation. Please retain the proof of purchase.
- The warranty will be void if there is any damage due to improper usage or modification of the luminaire.
- Failure to comply with the instructions in this manual may increase the risk of damage or injury and will void the warranty.
Important: Please Read Before Installation
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp
is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
- Tum off/unplug and allow to cool before replacing the lamp.
- Lamp gets HOT quickly! Contact only switch/plug when turning on.
- Do not touch the hot lens, guard, or enclosure.
- Keep lamps away from materials that may bum.
- Do not touch the lamp at any time. Use a soft cloth. Oil from the skin may damage the lamp.
- Do not operate the luminaire fitting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
Package Contents
- A. ( 1) Fixture
Product Dimensions
Remove Faceplate
Install Lamp
Insert the lamp with the correct wattage and type marked on the fixture label.
CAUTION: Do not exceed the maximum wattage marked on the luminaire label.
NOTE: DO NOT touch the lamp with bare hands. Use a soft cloth to handle
the lamp.
Installation Instructions
Install Faceplate
- Place the grass, gasket, and faceplate back onto the housing.
- Secure them with the screws previously removed.
- Hand tighten until snug, then use a screwdriver to secure the screws using a pattern.
Dig Hole
- Dig a hole in the ground making sure there is approximately 3 inches of room on all sides surrounding for pea gravel or sand.
Wire Connection
- Strip lead from the luminaire pigtail. Using wire connectors (sold separately), connect the leads from the luminaire to main supply cable leads.
Adjust Luminaire Direction
- Install the fixture in the hole and fill the extra space with pea gravel or sand for proper water drainage.
Install/Replace Bulb
Loosen the lock screw to remove the glare guard. Then remove the inner shield
to expose the bulb. Replace it with the correct wattage and type marked on the
fixture label. Then reinstall the inner shield and glare guard.
IMPORTANT: Halogen bulbs must be protected from moisture and dust at all
times. Always reinstall the shield when removed.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>