RayNeo ARRF60 Smart Ring User Manual
- June 12, 2024
- RayNeo
Table of Contents
RayNeo Ring user manual
Understand the product
Box contains
Controller x 1
Charging cable x 1
Silicone finger cover x 2
User manual x 1
Charging
Connect the magnetic suction line to the controller charging touchpoint for charging
Wear
Remove the controller, wear it as shown, use the thumb to control the buttons, Do not push hard to the end of the finger
Silicone Finger Cover Replacement
If the controller rotates during control, the small silicone finger cover can be replaced and used
Power on
In the shutdown or sleep state, press any key to wake up the controller
Sleep and shutdown
After the controller has no operation for 30s, it will enter a sleep state, and you can continue to use it by pressing any key.
Disconnect
Touchpad and return key are simultaneously pressed for 3s to disconnect the Bluetooth connection, and the controller is turned off
Product Information
Product name: RayNeo Ring
Product model: ARRF60
Wireless connection: Bluetooth
Battery capacity: 30mAh
FCC ID :2ACCJN066
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequence energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>