Aosspy 1009100254 Single Handle Commercial Modern Spring Kitchen Faucet Instruction Manual
- June 12, 2024
- Aosspy
Table of Contents
Aosspy 1009100254 Single Handle Commercial Modern Spring Kitchen Faucet
Installation
-
Ensure that the water supply below your sink is completely shut off by turning the shutoff valves all the way to the right.
Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. -
Remove the lock nut and brass spacer from the faucet body. Slide the tapered metal washer onto the faucet body followed by the rubber gasket. and insert into the base of the facet as shown. The tapered side of the washer should face up.
-
Insert the faucet into its mounting hole. From beneath the sink. slide the brass spacer back onto the faucet body. Thread the locknut back onto the threaded shank until hand-tight to secure. Finish tightening using an adjustable wrench.
-
Attach the sprayer hose to its copper mounting post as shown. Insert the provided rubber O-ring into the lock nut before securing. Apply a bit of thread sealant or plumber’s tape to the threads before tightening.
Important: Hand tighten, then use an adjustable wrench to give the lock nut no more than a¼ turn to complete tightening. Do not overtighten, which can crack or break the copper mounting post. -
Disassemble the provided hand sprayer hose weight by removing the two screws with Phillip’s screwdriver. From beneath the counter, measure 15″ down the hose from the faucet body. The weight will need to be mounted at this location. Clamp the two sides of the weight together and tighten the screws to secure.
-
Attach your main water lines to the copper water supply posts on the faucet. Ensure that you are connecting the hot and cold in accordance with the labels on the supply posts. Apply a bit of thread sealant or plumber’s tape to the threads before tightening.
Important: Hand tighten, then use an adjustable wrench to give the lock nut no more than a¼ turn to complete tightening. Do not overtighten, which can crack or break the copper mounting post. -
Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath.
-
Turn the faucet on and ensure that there are no leaks. Check to ensure that both hot and cold water are running properly. Turn on the hand sprayer function and allow the sprayer to run for another 60 seconds, and check for any leaks.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>