CORIculum Ramp with Winch Instruction Manual
- June 12, 2024
- CORI
Table of Contents
CORIculum Ramp with Winch
Product Information
The ramp with winch is a product designed for ages 5 and above. It requires 0.5-1 hour of grit to assemble. The ramp is constructed using Cori beams and can be customized to achieve the desired ramp steepness. The product comes with a winch assembly that can be used to pull objects up the ramp.
Product Usage Instructions
- Start by unfolding a Cori beam or cutting a piece of cardboard to the dimensions specified. Add two 12-inch beams to the ramp, allowing them to overhang about 2 inches. Use glue where indicated.
- Cut and fold three 6-inch Cori beams to create the ramp support structure. Ensure that the ramp from Step 2 fits between the vertical posts. Use glue where indicated.
- Glue the ramp from step 2 to the support structure from step 3 to achieve the desired ramp steepness. The recommended ramp angle is approximately 25 degrees.
- Glue the snap-in brackets to the top of the vertical beams, ensuring they are vertically aligned.
- Assemble the winch and crank arm according to the provided illustrations. Use glue if necessary.
- Snap the winch assembly into the brackets from step 5, ensuring it rotates freely.
- Tie a loop to one end of the string and tie the other end to the winch shaft. Turn the crank handle to pull an object up the ramp.
If you have any questions or comments, you can contact CORI support at support@coricreate.com. Don’t forget to share your designs using the hashtag
CoriCreate and follow CORI on Facebook, Instagram, and Twitter. For more
information, visit our website at www.coricreate.com.
Ramp with winch
- 0.5-1 hour
- Grit required
- Ages 5+
REQUIRED TOOLS
Assembly Instructions
INSTALLATION
- Start the ramp with an unfolded Cori beam, or cut a piece of cardboard to the dimensions below.
- Add two 12 inch beams to the ramp from step 1 letting them overhang about 2 inches. Glue where indicated.
- Cut and fold three 6 inch Cori beams to the dimensions below to form the ramp support structure. Make sure the ramp from step 2 will fit in between the vertical posts. Glue where indicated.
- Glue the ramp from step 2 to the support structure in step 3 to achieve desired ramp steepness. For this example, we chose a ramp angle of about 25 degrees.
- Glue the snap in brackets to the top of the vertical beams making sure they are vertically aligned.
- Assemble the winch and the crank arm as illustrated. Use glue if needed.
- Snap the winch assembly into the brackets from step 5. It should rotate freely.
- Tie a loop to one end of the string, and tie the other end to the winch shaft. Turn the crank handle to pull an object up the ramp.
CORI support is here to help. Contact us at support@coricreate.com if you have any questions or comments. Share your designs using our hashtag #CoriCreate. Follow us on Facebook, Instagram, and Twitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>