TRAEGER T09754-B Outdoor Kitchen Trim Kit Installation Guide

TRAEGER T09754-B Outdoor Kitchen Trim Kit

Product Information

The Outdoor Kitchen Trim Kit is a set of accessories designed to enhance the installation and functionality of your outdoor grill. It includes a kickplate, four foot brackets, four leveling feet, two screws with large washers (Screw Set A), and five spare screws  and washers.

Important Safety Precautions

• Fire Hazard: Exercise caution to prevent fire hazards.
• Electrical Shock Hazard: Take necessary precautions to avoid electrical shock.
• Grill Weight: The grill is heavy; always lift it with two people.

Tools Needed
The following tools are included with your grill:

• Kickplate
• 4 foot brackets
• 4 leveling feet
• 2 screws with large washers (Screw Set A)

Hardware Included
The hardware included with the trim kit consists of:

• Kickplate
• 4 foot brackets
• 4 leveling feet
• 2 screws with large washers (Screw Set A)
• Spare parts: 5 screws and washers

Additional Resources
If you need further assistance or information, you can scan the provided QR code or visit the Traeger website for support, the  Grill Assembly Guide, and the Grill Owner’s Manual.

Product Usage Instructions

Installing Assembled Grills
Before starting the installation process, make sure to unplug the grill.

1. Attach the leveling feet and kickplate according to the instructions provided in the “Installing Unassembled Grills” section.
2. Use Screw Set A to attach the kickplate. Leave the screws loose until all screws are placed, then tighten them to finish the installation.
3. Reassemble the grill by referring to the Grill Assembly Guide.

Installing Unassembled Grills
If you have an unassembled grill, follow these steps after completing step 6 of the Grill Assembly Guide:

1. Leave the screws loose until all screws are placed, then tighten them to finish the installation. Install leveling feet after attaching the brackets.
2. Refer to your Grill Assembly Guide to complete the assembly of your grill.

OUTDOOR KITCHEN TRIM KIT

INSTALLATION GUIDE  READ ALL INSTRUCTIONS BEFORE INSTALLING AND USING YOUR TRAEGER® GRILL.
IMPORTANT: Please read this Installation Guide and your Grill Assembly Guide and Owner’s Manual before installation and use of your Traeger® Grill. Failure to follow the instructions in this Installation Guide and your Grill Assembly Guide and Owner’s Manual could result in property damage, bodily injury, or even death.
Contact local building or fire officials about restrictions and installation inspection requirements in your area. Save these instructions. If you are assembling this trim kit for someone else, provide this Installation Guide for the owner to read and save for future reference.

IMPORTANT SAFETY PRECAUTIONS

WARNING Fire Hazard

• When operating your Traeger® Grill, maintain a MINIMUM distance of 20 inches (50.8 cm) from the grill to any nearby combustibles, including wooden railings, home siding, window frames, furniture, trees, and trash receptacles, etc.
• Do not install or operate this grill indoors or under a combustible ceiling or overhang.
• Do not install or operate your Traeger® Grill on combustible floors or surfaces.
• Do not put a grill cover or anything flammable in the storage space area under the grill.

WARNING

• Electrical Shock Hazard Hazardous voltage is present, which can shock, burn, or cause death.
• Ground Fault Circuit Interrupter (GFCI) protection must be provided on the circuit(s) or outlet(s) to be used for the operation of this Traeger® Grill.
• If using an extension cord, only use an extension cord suitable for outdoor use to prevent electric shock in accordance with the instructions and warnings accompanying that product.
• Do not modify the plug on your Traeger® Grill, the extension cord receptacle, or the extension cord plug in any way, including by removing the ground (earth) prong.
• Keep extension cord clear of snow and standing water.
• Ensure that the power cord and extension cord do not create a tripping hazard.
• When not in use, the extension cord should be removed and stored in a location protected from the sun and out of the reach of children.
• CAUTION Grill is very heavy. Always lift the grill with two people.

TOOLS NEEDED

(included with your grill)

HARDWARE INCLUDED

Kickplate

• 4 foot brackets
• 4 leveling feet
• 2 screws with large washers (Screw Set A)

SPARE PARTS

• 5 screws and washers

WE’RE JUST A SCAN AWAY

INSTALLING ASSEMBLED GRILLS

IMPORTANT: Unplug grill before disassembly.

Remove everything from inside the grill, including all internal components (grill grates, drip tray, EvenFlow™ Heat Shield, grease governor, and firepot), pots and pans, and food. Clean the entire grill, including any grease accumulation from the Traeger® Grease Management System (TGMS) and all ash and pellets from the grill and firepot (see “Maintaining Your Grill” in your Grill Owner’s Manual). (Casters can only be removed after Step 4).

NOTE: Save these screws for assembling the trim kit. if screws are damaged, spares are included in spare parts bag.

• Attach leveling feet and kickplate (see “Installing  Unassembled Grills” section).
  NOTE: Use Screw Set A to attach kickplate. Leave screws loose until all screws are placed, then tighten to finish.

• Reassemble by referring to your Grill Assembly Guide.

INSTALLING UNASSEMBLED GRILLS

After step 6 in your Grill Assembly Guide, refer to the instructions below:
NOTE: A 6 ft extension cord is included for the Induction Cooktop for counter installation.

Leave screws loose until all screws are placed, then tighten to finish. Install leveling feet after brackets are attached.

• Leave screws loose until all screws are placed, then tighten to finish. Install leveling feet after brackets are attached. assembly of your grill.

References

• Traeger Grills® - The Original Wood Pellet Grill

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>