Watercop WPCH Automatic Water Shut Off System Instructions
- June 12, 2024
- Watercop
Table of Contents
WPCH Automatic Water Shut Off System Instructions
WPC & WPCH Supplemental Wiring Guide
PRO by DynaQuip®
WPCH Automatic Water Shut Off System
RJ45 Connection
for security/automation or SmartConnect integration and/or use with wall
switch and CAT5E cable
Classic and Pro Interface
Contacts
RJ45 Socket
7 Brown/White (5VDC)
5 Blue/White (to close)
6 Green (to open)
CAT5-E
3 Green/White
4 Blue
2 Orange
WIRING GUIDE
WPACT12V available with 25, 50, 75′ or 150′
cable
Note: When using WPC or WPCH to only
control a remote replay (no WPACT12V attached) jumper wires must be attached
as shown
The proven leader in household leak protection: WaterCop® is there when
you’re not.
WPC/WPCH Supplemental Wiring Instructions
Relay wiring to control ancillary devices such as well pumps, recirculating
pumps, secondary WPACT12V WaterCop valves or DynaQuip DE series actuators.
Note: Use “NEMA” terminals on WPRLY socket
Note: For low voltage WCDE###H Series, use a 12 VDC power
supply instead and wire like the 120 VAC except no ground is required.
To order or for additional information, visit watercop.com or call
800-545-3636.
DQ PART NUMBER 192458 REV F
Made in the USA