velleman K4006 Power Supply User Manual

: June 12, 2024
: Velleman

Table of Contents

velleman K4006 Power Supply
Product Usage Instructions
Assembly hints
Construction
PCB layout
Diagram
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

velleman K4006 Power Supply

Product Information

Total solder points: 36
Difficulty level: beginner 1 2 3 4 5 advanced
Power supply for K4004B and K4005B
K4006
ILLUSTRATED ASSEMBLY MANUAL H4006IP-1

Product Usage Instructions

Assembly Hints:
- Make sure you have the right tools, including a basic multi-meter for some projects.
- Always look for possible last-minute manual updates indicated as ‘NOTE’ on a separate leaflet.
Soldering Hints:
Mount the component against the PCB surface and carefully solder the leads.
Make sure the solder joints are cone-shaped and shiny.
Trim excess leads as close as possible to the solder joint.
Construction:
- Refer to the HALG (general manual) or visit our website for the color code for resistances and LEDs: http://www.velleman.be/common/service.aspx
- Follow the PCB layout and diagram for assembling the components.
Connection:
- Refer to the provided table for the connection details based on the specific product model (K4004B, K4005B).
- Ensure correct polarity for LEDs, bridge rectifier, and electrolytic capacitors.

For any further assistance or inquiries, please contact VELLEMAN Components NV:

Address: Legen Heirweg 33, 9890 Gavere, Belgium, Europe

Website: www.velleman.be,
www.velleman-kit.com

Product Support: +32 410329 311575

Assembly hints

Assembly (Skipping this can lead to troubles ! )
Ok, so we have your attention. These hints will help you to make this project successful. Read them carefully.

Make sure you have the right tools:

A good quality soldering iron (25-40W) with a small tip.
Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look. This is called ‘thinning’ and will protect the tip, and enables you to make good connections. When solder rolls off the tip, it needs cleaning.
Thin raisin-core solder. Do not use any flux or grease.
A diagonal cutter to trim excess wires. To avoid injury when cutting excess leads, hold the lead so they cannot fly towards the eyes.
Needle nose pliers, for bending leads, or to hold components in place.
Small blade and Phillips screwdrivers. A basic range is fine.

For some projects, a basic multi-meter is required, or might be handy

Assembly Hints :

Make sure the skill level matches your experience, to avoid disappointments.
Follow the instructions carefully. Read and understand the entire step before you perform each operation.
Perform the assembly in the correct order as stated in this manual
Position all parts on the PCB (Printed Circuit Board) as shown on the drawings.
Values on the circuit diagram are subject to changes.
Values in this assembly guide are correct*
Use the check-boxes to mark your progress.
Please read the included information on safety and customer service

Typographical inaccuracies excluded. Always look for possible last minute manual updates, indicated as ‘NOTE’ on a separate leaflet.

Soldering Hints