gameset CONTROL 1.1 EKGS8108 Table Instruction Manual

gameset CONTROL 1.1 EKGS8108 Table

Note

1. Operatin voltage: AC100~240V, frequency 50/60Hz.
2. Operating temperature: -10~40°C.
3. Before use, please check whether all power lines are fully connected an firm.
4. Before use, please check the surrounding environment and ensure there are no obstructions above or below the table.
5. This product is not to be used by children. Adult supervision is required.
6. Do not use if any cables (electrical parts) are damaged.
7. The product is not suitable for mobile use. If you must move, please prevent it from being injured.
8. It is normal for a slight jitter when the table starts to rise and fall. This will not affect the servie life.

INSTRUCTIONS

1. Restore Factory Settings
   • Run the desktop to the lowest point after power on, Press and hold „ ” and „ “Key at the same time, until,–” is on the screen, and release the button. The system automatically enters the initialization mode, the table will run automatically. When it stops, the initialization is succesfull.When the new table is installed, please do this first.
2. Run Up and Down
   • When press and hold „ ” key The desktop runs upwards until it reaches the highest point.
   • When press and hold the „ ” key The desktop runs downwards until it reaches the lowest point.
3. Memory Storage and Operation
   • Standing Memory: Run the desktop to the standing height you want, long press „M” key, when the displays shows „5–” then release the key, press „ “key, display shows „5–H” means standing memory saved successfully.
   • Sitting Memory: Run the desktop to the sitting height you want, long press „M” key, when displays shows „5–” then release the key, press „ ” key, display shows „5– ” means sitting memory is saved successfully.
   • Press „ / ” key more then 3 seconds, height display flashes, release the key, the table will automatically run to the memory point.
   • Note: When setting the memory height, the height of the standing memory (high point) is higher than that of the sitting memory (low point), othwewise the memory cannot be saved.
4. Sedentary Reminder
   • Turn on the reminder: Press „M” key, the display shows „ , 30/45/60 minutes respectively.
   • When the time is up, the display will flash „Chr”for 1 minute. After 5 consecutive reminders, if the table is not used, the system will automatically turn off.
   • Turn off Reminder: Press „M” key, when the display shows the height, reminder is off.

ERROR RETRIEVAL

Auto Lock

• If desk is taken through 5 fully cycles in a row, it will be automatically locked to prevent overheating. It needs to be powered off and on again to continue use.

Error Code Form

Method to Restore Factory Settings

• Press and hold „ ” and „ ” Key at the same time, until „” is on the screen, release the button, the system automatically enters the initialization mode.

Exception handle (Abnormal noise and wobble)

• Check whether the table legs are perpendicular to the table top, re-tighten the upper table legs screws and inclined strut screws.

Overview

Installation Instructions

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>