ERGOUP Double Leg Rest for Office Chair Instruction Manual
- June 12, 2024
- ERGOUP
Table of Contents
Double Leg Rest for Office Chair
Instruction Manual
Double Leg Rest for Office Chair
Ergo UP Installation:
Disclaimer: We are not medical professionals. Consult your doctor for specific
usage of this device for injury or illness.
The Ergo UP Leg Support will fit nearly any office chair. No tools are needed
to setup the Ergo UP for use, and it should take only a few minutes to
install.
First make sure all the parts included on the packing list are in your box.
Step 1 Assemble the ErgoUP
Insert the two Casters into the two legs, pushing firmly.
Holding the frame so the casters are on the floor, slide the T Post that is
attached to the Cushion into the top center hole of the frame.
Be sure the Coupler with Velcro strap is inserted into Frame Base.
Your Ergo UP should now look like the image to the left.
Step 2 Prepare Your Chair
Most office chairs have a telescopic plastic sleeve that covers the main
cylinder of the chair, normally there are three sections to the sleeve. You
must slide the bottom section up to expose the cylinder, which is where the
Ergo UP attaches to the chair.
Step 3 Installing the Ergo UP
Open the Velcro strap, leaving it threaded through the Coupler. Now wrap the
strap around the chair cylinder and close the Velcro strap.
Step 4 Adjust the Ergo UP
First make sure your chair is properly adjusted. Now, set the distance by sliding the Coupler in or out of the Frame Base so that the back edge of the pad is directly behind your knee. Tighten the Adjustment Knob to lock into position. (If the frame appears to be too small, an XL adaptor is available.) Next, adjust the height of the Ergo UP so that your knee is comfortable, and tighten Adjustment Knob below the cushion. It is recommended that the pad be positioned so that it is parallel along the leg and provides even support. Pressure points along the edge of a pad can restrict circulation
The adjustable pitch or pivot is designed so that the pad floats to the natural position of the leg, with knee bent slightly. The resistance can be adjusted under the pad where the steel “T” post connects to the underside. There are two clamps connected with four Phillips head screws. Turn screws clockwise to add resistance, or turn screws counterclockwise to loosen.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>