Yoelbaer YB Wireless Backup Camera System Instruction Manual

HD Recorder
< Instructions for use>

Friendly reminder

This product uses a high performance chip to provide high definition video with seamless motion picture .
Support FHD1080P true full HD camera. Please read this manual carefully before use and keep it properly, we hope this product can meet your needs and serve you for a long time!

Installation guide

1. Turn off the car engine.
2. Insert the SD card into the recorder card slot. Note] Please use high speed SD card (Class10 or above), capacity not less than 8GB, SD card supports 128GB maximum.
3. Fix the recorder on the center console of the car.
4. Install the rear camera in the rear of the vehicle, pay attention to the direction when installing.
5. Adjust the lens position to make sure the lens is level with the ground.
6. Start the engine and check if the machine has been installed correctly.

Caution:

1. Note: Please do not unplug the SD card while the machine is working to avoid damage.
2. Please note the direction of SD card insertion, if inserted upside down, it may damage the machine and SD card.
3. When you insert the SD card into the machine, the machine will set the SD card as the preset storage device, and the data in the original SD card may not be read.
4. If the SD card is not compatible with the machine, please insert it again or try again with another SD card.
5. Please format the SD card first time you insert it.

Wiring method

Parameter analysis

Key Explanation

1. Click witching channel, can switch channel 1/channel 2/channel 3/channel 4.
2. Click  Pop-up menu settings menu.
3. Click Start Video, Click again stop Video,  The recording screen is the currently displayed channel screen. When you need to record other channels, Direct Click After switching channels, Click again You can start recording now;
4. Click Turn on the reversing line, Click again Eliminate the reversing line;
5. Click Start up, Click again Shutdown;

Setting

(1) Short press [MENU] , Go to the Setup Video screen

1. [Pairing a wireless monitor with a wireless camera] Select , Short press [OK] Start automatic search pairing, pairing completed automatically exit (need to pair which channel that switch to the corresponding channel can be)

2. [Brightness/contrast/tone/sound settings] Select Enter Short press [ “—” / “+” ] Skip selection, Press [ok] Enter, Press [ “—” / “+” ] Adjust the value, After setting, short press [MENU] Back.

3. [Screen flip] Select Enter
   Short press [ “—” / “+” ] Skip selection, [ok] Confirmation, [MENU] Return.

4. [Screen display screen settings] Select Enter
   Short press [ “—” / “+” ] Skip selection, Press [ok] Confirmation, After setting, short press [MENU] Return.

5. [Camera channel screen / channel screen dwell time] Select Enter
   Short press [ “—” / “+” ] Skip selection, Press [ok] Confirmation, After setting, short press [MENU] Return.![Yoelbaer YB Wireless Backup Camera System

• fig12](https://manuals.plus/wp-content/uploads/2023/07/Yoelbaer-YB-Wireless- Backup-Camera-System-fig12.png)

  6. [VCR settings] Select Enter
     Short press [ “—” / “+” ] Skip selection, Press [ok] Confirmation, After setting, short press [MENU] Return.![Yoelbaer YB Wireless Backup Camera System

• fig14](https://manuals.plus/wp-content/uploads/2023/07/Yoelbaer-YB-Wireless- Backup-Camera-System-fig14.png)

  7. [VCR settings] Select Enter
     Short press [ “—” / “+” ] Skip selection, Press [ok] Confirmation, After setting, short press [MENU] Return.

  8. [Formatting settings] Select Enter
     Short press [ “—” / “+” ] Skip selection, Press [ok] Confirmation, After setting, short press [MENU] Return.

FCC Warning:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, macaques harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is  encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>