MBW U-COM 8R Motorcycle Intercom User Manual
- June 12, 2024
- MBW
Table of Contents
U-COM 8R Manual
Charging
Red LED: Charging Blue LED: Fully charged
Power On/Off
Power On : Center Button + Music Button for 1 sec
Power On : Tap the Center Button + Music Button
Volume Adjustment
+ Button – Increase the volume
– Button – Decrease the volume
Battery Check
Phone, Music Pairing
- To access Configuration Menu, press and hold the Center Button for 10 second.
- To enter Phone Pairing, tap the + Button.
- Search for Bluetooth devices on your mobile phone. Select the headset in the list of the devices detected on the mobile phone.
- Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
Music Operation
Play music: Press the Music Button for 1 second.
Pause music: Press the Music Button for 2 second.
Track back: Press the – Button for 1 second.
rack forward: Press the + Button for 1 second.
Mobile Phone Call Making and Answering
Answering a call: Tap the Phone Button Ending a call: Press the Phone- Button for 2 seconds. Speed dial: Press the Phone Button for 3 seconds. Rejecting a call: Press the Phone Button for 2 seconds.
Mesh Intercom On/Off
Tap the Intercom Mesh Button.
Intercom Pairing
- Press and hold the Center Button of two Bluetooth systems for 5 seconds until red LEDs of both units start to flash rapidly
- The two headsets will be automatically paired.
Intercom Start/End
1st Friend: Tap the Center Button once.
2nd Friend: Tap the Center Button twice.
3rd Friend: Tap the Center Button triple times
Setting
Configuration Menu: Press the Center Button for 10 seconds.
Troubleshooting
Factory Reset
If you want to restore the headset to factory default settings, use the
Factory Reset in the configuration menu. The headset automatically restores
the default settings and turns off.
Certification and Safety Approvals FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and
off, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antennae
-Increase the separation between the equipment and the receiver
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific operating
instructions for satisfying RF exposure compliance. The antenna used for this
transmitter must not transmit simultaneously with any other antenna or
transmitter, except in accordance with FCC multi-transmitter product
procedures. When equipped, the distance between antenna and one’s head surface
is 59.5mm.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void user’s authority to operate the
equipment.
Industry Canada(IC) Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.