Starkrimson Duo-Trio Preorder Audio Power Amplifier Instructions
- June 12, 2024
- Starkrimson
Table of Contents
Starkrimson Duo-Trio Preorder Audio Power Amplifier
Product Information:
The product in question is an amplifier. It is designed to enhance audio signals and provide amplified sound output. The amplifier has a warranty that covers certain types of damage, but it is important to note that improper powerup or power down of the amplifier may cause damage that is not covered under the warranty.
Product Usage Instructions:
To ensure proper usage and avoid any potential damage that may void the warranty, please follow these instructions:
- Powering Up: Before powering up the amplifier, make sure it is connected to a compatible power source and all necessary audio inputs and outputs are properly connected.
- Powering Down: When you are finished using the amplifier, follow the proper power down procedure. This typically involves turning the amplifier off using the designated power button or switch.
- Avoid Power Surges: Protect the amplifier from power surges by using a surge protector or a reliable power supply with built-in surge protection.
- Avoid Overloading: Do not connect the amplifier to speakers or devices that exceed its recommended power rating. This can cause damage to both the amplifier and the connected equipment.
- Proper Ventilation: Ensure that the amplifier has adequate ventilation to prevent overheating. Avoid placing it in enclosed spaces or blocking the air vents.
- Transportation: When moving or transporting the amplifier, handle it with care and avoid any rough or sudden movements that could potentially cause damage.
By following these usage instructions, you can maximize the lifespan of the amplifier and prevent any potential damage that may not be covered under the warranty.
NOTES:
- Due to the bridged amplifier design, all speaker terminals are hot when the amplifier is on.
- Warning – High Voltage
- Do not connect any of the outputs to ground or earth.
- Do not power up or operate the amplifier without speakers connected to all channels.
- No user-serviceable parts – tampering with the amplifier will void the warranty.
To turn the amp on:
- Connect speakers to all channels
- Connect Inputs (XLR) on all channels
- Plug-in the power cord (switch must be in the off position)
- Turn the amplifier on by flipping the switch to the on position.
To turn the amp off:
- Turn it off by flipping the switch to the off position.
- Wait at least 15 seconds before removing any connections Improper powerup or power down of the amps may cause damage and this damage will not be covered under the warranty.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>