BZ IB-DX-620 Car Loudspeaker System Installation Guide
- June 12, 2024
- BZ
Table of Contents
DSERIES MANUAL
IB-DX-620 Car Loudspeaker System
Thank you for your purchase of Car-Audio Speaker Systems. Please read the
following installation and operation guidelines carefully to ensure many
years enjoyment of car audio speaker system. All Speaker Systems products
should be set-up and installed by authorized and licensed technicians.
Though this manual narrates the installation, it didn’t show the remove of
car.If you got no experience of this, please don’tset up by yourself,you can
inquire at the experienced car service office. ‘
——— Please note your car is on flameout situation! :
Circuit diagram Please connect according to the following circuit diagram
Tweeter installation
- Fetch the tweeter from the back, drill three screws on the back grill according to the graph. (Adjust the back grill orientation to get the best listening effect)
- Fix the back, put the tweeter in it.
Woofer installation
- Down the car glass to the bottom, put the woofer into the Install hole, make sure not to affect the car window, if do, when equipped you have to add the collocate gasket we offer.
- Put the woofer to the position you want to install, marking your screw position, then drill 6 holes with the 3.5mm aiguilles.
You can omit this process if your original hole is conformable. And then screw the gasket. And the woofer on to the door, air leak is forbidden, which is crucial to the woofer playback.
Installation of crossover
- Please make sure to check that the crossover will properly fit in the place you have selected for mounting. Once you are sure the position is ideal screw then crossover into position (See figure below).
Connection
- Tweeter/ Bass connection diagram.
Notice: Three tweeter options of •2dB, OdB, -2dB for you choose dependant
on your cars internal acoustic environment and individual tastes.
Notice
Remove wire insulator bout 5mm not longer (See figure as below), in order to
protect circuit, avoid causing a short circuit between the anode (•) and
cathode (-) cables of loudspeaker. Rest wire core tightly and do not overlap
the cables!
Specifications:
Model | DX-620 |
---|---|
6.5″midrange woofer | DX620W |
28mm silk dome tweeter | DX28T |
Sensitivity | 88dB |
Frequency Response | 60-20KHz |
Max Power | 120W |
Power Handling | 60W |
Rating Impedance | 40 |
Installation Size | 0158mm |
Hole Size | 0140mm |
Installation Depth | >68mm |
Net size | 0175x18mm |
Crossover point | 3.6KHz |
High pass decay rate | 12dB/Octave |
Low pass decay rate | 12dB/Octave |
HI-END CAR LOUDSPEAKER SYSTEM
www.hivi.com
Because of the design change,the illustration may not conform to the
practicality. We will not inform again!
Documents / Resources
| BZ
IB-DX-620 Car Loudspeaker
System
[pdf] Installation Guide
IB-DX-620 Car Loudspeaker System, IB-DX-620, Car Loudspeaker System,
Loudspeaker System, System
---|---