VSI Legacy Series Brine Maker Installation Guide
- June 12, 2024
- VSI
Table of Contents
LEGACY SERIES BRINE
MAKER WIRING
REGARDING: Wiring Diagram for Legacy Series Brine Maker
Digital Salinity Meter
The Legacy Series Brine Maker includes a digital salinity reader. This
salinity reader is received from the factor with an un-wired cord to an
electrical box with switch. This allows the end user to provide power
customized to their needs. See below instructions for wiring of this digital
salinity reader. Unit should be wired to 110V, 15 Amp circuit.
Included:
- Part A: 18 AWG, 2 cord wire (black and white)
- Part B: Weatherproof, Non-Metallic, 1-Gang box, ¾” Outlets
- Part C: 1 Gang Cover for Toggle Switch
Not Included:
- Part D: Stationary Toggle Switch (Recommended: 15 A, 120V, Stationary Toggle)
- Part E: 14 AWG, 15A, 125V AC, 3 Wire Cord (Black, White, Green)
- Part F: Twist on Wire Nut
Electric Motor for Pump
The Legacy Series Brine Maker includes an electric motor and pump. This motor
is not prewired to allow the end user to provide power customized to their
needs. See below for wiring recommendations. Please note the special
instructions and load. Unit must be wired to 220V, Single Phase, 30 Amp
circuit. Motor MUST be wired for OPPOSITE rotation (the color guide below will
ensure this is correct for opposite rotation).
Included:
- Part G: Centrifugal pump, cast iron, 5 HP, 3450 RPM, ODP, 220V
Not Included:
- Part H: Twist on Wire Nuts
- Part J: 10 (or 8) AWG, 3 Wire (Black, White, Green)
- Part K: 220V Outlet
Should you have any questions please contact VSI at
507-252-3033 or email us at
sales@vsinnovation.com.
Thank you,
Voigt Smith Innovation LLC