ZOSTUIC B0C3GR3W7D Digital Camera User Manual
- June 12, 2024
- ZOSTUIC
Table of Contents
ZOSTUIC B0C3GR3W7D Digital Camera
Warm Tips
Since this product was designed for kids, we recommend shooting outdoors in bright light
Q: Does this camera need to be charged prior to first use?
A: Yes, we suggest you fully charge the camera before use.
Q: After putting in the Micro SD card and everything else, it still says
card error and what should I do?
A: Please make sure your card is class 10 U1 32GB card, and put it in the slot
again, if it still can’t work, please contact the seller for help.
Q: The camera freezes up and can’t turn off, what can I do next?
A: Please remove the battery, then install the battery again and turn the
camera on, format SD card.
Q: What is the best shooting distance?
A: Since this camera is a fixed focus lens and cannot be replaced, the best
shooting distance is 3.3 feet away. Please note that this camera cannot
autofocus.
Important Battery Safety Tips
For your better experience with this product, please pay attention to the following safety tips If the battery pack is mishandled, the battery pack can burst, cause a fire or even chemical burns. Observe the following cautions.
- Do not disassemble.
- Do not crush and do not expose the battery pack to any shock or force such as hammering, dropping or stepping on it.
- Do not short circuit and do not allow metal objects to come into contact with the battery terminals.
- Do not expose to high temperature above 60°C (140°F) such as in direct sunlight or in a car parked in the sun.
- Do not incinerate or dispose of in fire.
- Do not handle damaged or leaking lithium ion batteries.
- Be sure to charge the battery pack using a genuine battery charger or a device that can charge the battery pack.
- Keep the battery pack out of the reach of small children.
- Keep the battery pack dry.
- Replace only with the same or equivalent type recommended by seller.
- Dispose of used battery packs promptly as described in the instructions.
Introduction of Camera Parts
| |
---|---|---
| Power Button| Power the camera on/off
2
| ****
Shutter Button
| In image mode: take photos
In video mode: start/end recording
In playback mode: play/pause playing video file
3
| ****
W Button
| Electronic zoom/zoom out
In playback mode: reduce the sound of the video
4
| ****
T Button
| Electronic zoom/enlarge
In playback mode: enlarge the sound of the video
5| Mode Button| Switching camera modes: image mode/ video recording mode/playback mode
6
|
Menu Button
| Enter or exit menu settings.
In image mode: image mode setting In video mode: video mode setting In playback mode: delete flies
---|---|---
7
| OK Button| Confirm selection button
In playback mode: stop playing video file
8| Up| Up key: turn on or off fill light
/menu selection
9| Down| Down key: shortcut delete key
/menu selection
10
|
Left
| Left button: timer seine button
(in image mode, press it to set the timer photo count down time 2s, 5s or 1Os)
/menu selection
11
| ****
Right
| Right key: In image mode, continuous shooting button (press this button to
take 3 photos in a row)/menu selection.
---|---|---
12
| ****
Indicator light
| 1. The blue light indicates that the camera is working;
2. The red indicator light indicates that the camera is charging;
3. The red light goes out when fully charged
13| Hook| Attachable camera strap
14| Tripod mount| Standard screw port
15| Battery cover| Install battery and Micro SD card
16| LED flll light| LED flll light
17| MIC Port| Recording voice
18| USB| Type-C USB
19| Speaker| Play sound
Product Specifications
How to Insert and Remove the Battery
- 0pen the battery cover
- lnsert the end with electrical contacts until it locks into place
- Close the battery cover
- Please push the battery lock lever to remove the battery
How to Charge the Camera
- Please use the USB cable and charger included in the package to charge the camera.
- When the camera indicator light is red, it means the camera is charging.
- When the camera light goes out, it means the camera is fully charged.
Please note
For the first time, please use the camera after fully charged.
How to Insert and Remove Micro SD Card
- Open the battery cover
- As shown by the illustration, face the card’s metal contacts side toward you and insert it until it locks in place.
- Close the battery cover.
Please caution
- When the Micro SD card is used for the first time, please format it in the camera.
- Please keep press the card until the lock lever locks the card. When the card is locked, you will hear a “click” sound.
How to Format a Memory Card
- In the image mode, press the “Menu” button to enter the image mode setting interface
- Press the “Left” and “Right” keys to find the “Format” option
- Press “OK” button to confirm formatting
Introduction to Image Mode Settings
- Press the “Menu” button in the image mode to enter the camera image mode settings
- After the setting is completed, please press the “Menu” button to exit the image mode settings
How to Take Image
-
Please make sure the camera is in image mode
( The camera defaults to image mode when turned on) -
Press the “shutter” button to shoot an image
How to Play Back and Delete Image
- Press the “Mode” button twice in the image mode to enter camera playback mode
- Press “Right”or “Left” button to playback image one by one
- Press “Down”button and select “Yes” to delete image
- Please press the “Mode” button to exit image playback mode
How to Record Video
- The camera defaults to image mode when turned on, you need to press the “Mode”button once to enter video mode
- Press the shutter button to start/stop video recording
How to Play Back and Delete Recorded Videos
- Press the “Mode” button once in the video mode to enter camera playback mode
- Press “Right”or “Left” button to select video
- Press “Down”button and select “Yes”to delete video
- After the deletion is completed, please press the “Mode” button to exit video playback mode
How to Download Image/ Video Files to Computer
- When the camera is turned on, use the USB cable (in the package) to connect the computer
- Then you can download the flies from the camera to your computer
- After downloading, please remove the USB cable
How to Use Camera as Webcam
- Please turn off the camera and use the USB cable (in the package) to connect the computer
- Then please press the “Power” Button and “Shutter” Button at the same time
- Then you can use the camera as webcam on the computer
- After using, please remove the USB cable and the camera will exit webcam mode
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>