Best Choice Products Kids 12V Ride On Truck User Manual

Best Choice Products Kids 12V Ride On Truck

Safety: Please retain these instructions for future reference.

This vehicle must be assembled by an adult who has read and understood the instructions in this manual. Keep the packaging and bags away from children and dispose of all packaging before use. Always use common sense and safe practices when operating this vehicle. This product contains or emits chemicals known in the state of California to cause cancer or birth defects or other reproductive harm.
NOTE: For best performance, only use this vehicle on flat and hard surfaces.

• Age Range: 3 to 8 years old
• Weight Capacity: 65 lbs.

The following safety hazards may result in serious injury or death:

• This product contains small parts. Keep children away during assembly. Make sure to remove all packaging material and parts from underneath the vehicle body.
• Never open the battery. Batteries contain lead and lead compounds (acids) that are toxic and corrosive, and known to the state of California to cause cancer and reproductive harm.
• Limbs, hair, and clothing can get caught in moving parts. Always wear shoes, keep limbs away from moving parts, and do not wear loose clothing while operating this vehicle.
• This vehicle does not have brakes or braking capability. Do not leave a child unattended during operation. Do not use this in a location that may require braking capability, as this could result in loss of control, which may cause serious injury or death.
• Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night, or in the dark could result in an unexpected accident.
• Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand, or gravel may result in an unexpected accident such as tipping over, and could damage the electrical system or battery.
• Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:
  • Pulling the vehicle with another vehicle or similar device
  • Allowing more than one rider
  • Pushing the user
  • Traveling at an unsafe speed

Battery Warning
The following safety hazards may result in serious injury or death:

• Use of a battery or charger other than the supplied 12V rechargeable battery and charger may cause a fire or explosion. Only use the supplied battery and charger.
• Use of the 12V rechargeable battery and charger for any other product may result in overheating, fire, or explosion. Never use the supplied rechargeable battery and charger with another product.
• Explosive gases are created during charging. Charge the battery in a well-ventilated area. Do not charge the battery near heat or flammable materials.
• Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact between the terminals. Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire. Always pick up the battery by its case or handles.
• Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not induce vomiting.
• Battery posts, terminals, and related accessories contain lead and lead compounds (acid) – chemicals known to the State of California to cause cancer, reproductive harm, and are toxic and corrosive. Never open the battery.
• Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep the charger housing closed.

Warning: To reduce the risk of injury, adult supervision is required. Never use on roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never allow more than one rider.

• Never leave a child unattended.
• Always sit in the seat when using this vehicle.
• Keep your hands, hair, and clothes away from moving parts.
• Children under 3 years of age cannot use the vehicle.
• Only drive on level ground.
• Do not drive the vehicle into loose dirt, mud, sand, fine gravel, or on wet surfaces.

CALIFORNIA PROPOSITION 65
WARNING: Battery posts, terminals, and related accessories can expose you to chemicals including lead and lead compounds, which are known to the State of California to cause cancer and birth defects or other reproductive harm, and are toxic and corrosive. Wash hands after handling. For more information go to www.P65Warnings.ca.gov

CARING FOR YOUR RIDE-ON

• Park the vehicle indoors or cover it with a tarp to protect it from wet weather.
• Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or cover with tarp.
• Do not wash the vehicle with a hose.
• Do not wash the vehicle with soap.

SPECIFICATIONS

WARNING
ADULT ASSEMBLY REQUIRED

WARNING
CHOKING HAZARD – Small parts. Not for children under 3 years old.

TOOL REQUIRED

HARDWARE

Parts-Box A

Parts-Box B

Product Assembly

1. Flip the vehicle over and lay it on a level surface. Remove the brackets holding the part A rear axle, then remove the axle.
   Remove the nuts and washers from the rear axle.

2. Remove packaging from gear boxes and lift up the rear shocks. Line up the gear boxes with the shocks, then slide the part A rear axle through.

3. Slide a part B rear wheel onto the axle and replace a nut and washer to secure the wheel. Repeat on the other side.

4. Snap a part D hub cap onto each wheel.

5. Remove two nuts from the bottom of the part K front axle. Slide two part 4 springs onto the part P axle frame.
   Attach the springs and axle frame to the front axle by replacing the two nuts.

6. Remove the nut and washer from the steering column. Slide the front axle assembly onto the steering column and secure it by replacing the nut and washer.
   Place the front axle assembly into the designated slots and secure it with eight part 1 screws, four on each side.

7. Remove two nuts and washers from the front axle.
   Slide a part C front wheel onto the axle and replace a nut and washer to secure the wheel. Repeat on the other side. Snap a part D hub cap onto each wheel. Use the provided plastic wrench to attach the nuts.

8. Join the connector from the part L steering wheel to the corresponding connector in the steering mount, then snap the steering wheel into place.
   NOTE: To remove, compress buttons on the sides of the steering wheel.
   Insert the two part E frame pieces into the designated holes on the rear of the vehicle.

9. Slide the part F bar light into the holes located on the frame pieces and secure it with two part 2 screws.

10. Snap on the part H winshield

11. Snap on two par t I side mirrors.

12. Attach the part J seat with two part 1 screws.

13. Slide the two part M front reflectors onto the front of the vehicle and they will snap in place.

14. Under the hood, join the orange connector from the battery to the corresponding connector from the control module.

DASHBOARD DIAGRAM

Push down on the pedal to drive forward/reverse. Release the pedal to slow down and stop.

MEDIA PLAYER

• Back/Volume-: Short press to play the previous song/radio station, long press to decrease volume
• Play/Pause/Seek: Play/pause music, seek radio stations
• Forward/Volume+: Short press to play the next song/radio station, long press to increase volume
• Mode: Press to toggle between music and FM radio

BLUETOOTH

1. Place your desired audio device near the media player and power the car on.
2. Press Mode on the media player and wait until you hear “Bluetooth device is ready to pair.”
3. On your desire audio device, locate the Bluetooth setting and select the device named “Best Choice Products Ride On.”
4. When the device says “Your Bluetooth device is connected successful/Y,” select the desired song.

REMOTE CONTROL DIAGRAM

• Insert 2 AAA batteries into the remote control
• After 10 seconds of non-operation, the indicator light will turn off and the remote will go into power-saving mode.

Linking the remote control:

1. Press and hold the frequency key for 2 to 4 seconds. The low speed LED lights will flash.
2. Turn the vehicle on. The low speed LED lights will stop flashing and remain on to indicate a successful link.
3. If the low speed LED lights continue to flash (indicating an unsuccessful link), remove the battery on the remote and repeat steps 1 and 2.

CHARGING INSTRUCTIONS AND WARNING

• Charging socket is located under the dashboard on the left side. Insert one end of the part O charger into the charging socket and plug the other end into a wall outlet (see Dashboard Diagram).
• Charge the battery at least 12 hours before initial use.
• On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty.
• Damage to the battery may occur if it is allowed to drain completely. Do not allow the battery to drain completely.
• Check the battery and charger (supply cord, connector) for wear and damage before charging.
• Do not charge the battery if damage has occurred.
• Only an adult who has read and understood the safety warnings should handle, charge and recharge the battery.

1. Open the Hood of the vehicle and disconnect the orange connector joining the battery to the control module.
2. Insert the part O charger into the battery charging socket and plug the other end into a wall outlet. (See Dashboard Diagram)
3. Charge the Battery for 8 to 10 hours, then disconnect.
4. Remove the charger after charging and reconnect the battery to the control module. (Diagram)

WARNING REDADING BATTERIES

• Do not mix alkaline, standard (carbon zinc) and rechargeable (nickel hydride) batteries.
• Do not mix old and new batteries.
• Non-rechargeable batteries should not be charged.
• Rechargeable batteries should be charged under adult supervision only.
• Exhausted batteries should be removed.
• The supply terminals should not be short-circuited.
• Do not put batteries next to or in a heat source (fire, electronic heating device, etc.).
• Do not hit batteries against hard objects.
• Do not submerge batteries in water.
• Batteries should be inserted with the correct polarity.

TROUBLESHOOTING

connectors
Charger not connected to socket or outlet| Completely plug in the charger
Battery does not last| Battery does not have a full charge| Fully charge the battery
Battery is warm and makes a slight noise while charging| Normal| Normal
Slow speed| Low battery| Fully charge the battery
Overloaded vehicle| Reduce the weight on the vehicle
Uneven or sloped road| Drive on flat pavement
Vehicles shakes while driving| Loose connection to motor| Ensure the motor is properly connected to the battery
Vehicle is silent| Steering wheel is not properly connected| Properly connect the steering wheel connector

FCC COMPLIANCE STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

1. This product may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Responsible party (contact for FCC matters only):
Quality Control Dept.
15101 Red Hill Ave.
Tustin, CA 92780

Question about your product? We’re here to help. Visit us at: help.bestchoiceproducts.com

PRODUCT WARRANTY INFORMATION

All items can be returned for any reason within 60 days of the receipt and will receive a full refund as long as the item is returned in its original product packaging and all accessories from its original shipment are included. All returned items will receive a full refund back to the original payment method. All returned items will not be charged a re-stocking fee.
All returned items require an RA (Return Authorization) number, which can only be provided by a Best Choice Products Customer Service Representative when the return request is submitted. Items received without an RA may not be accepted or may increase your return processing time. Once an item has been received by Best Choice Products, refunds or replacements will be processed within 5 business days.
All returns must be shipped back to the Best Choice Products Return Center at the customer’s expense. If the reason for return is a result of an error by Best Choice Products then Best Choice Products will provide a pre-paid shipping label via email. Boxes for return shipping will not be provided by Best Choice Products, and is the customer’s responsibility to either use the original shipping boxes or purchase new boxes.
Pictures may be required for some returns to ensure an item is not damaged prior to its return. Items returned are not considered undamaged until they are received by Best Choice Products and verified as such. All damages to items are the customer’s responsibility until the item has been received by and acknowledge by Best Choice Products as undamaged.

WARNING
Manufacturer and seller expressly disclaim any and all liability for personal injury, property damage or loss, whether direct, indirect, or incidental, resulting from the incorrect attachment, improper use, inadequate maintenance, or neglect of this product.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>