UNITY Tactical Cold Weather Liner for Ballistic Helmets Instruction Manual

Table of Contents

UNITY-Tactical-Cold-Weather-Liner-for-Ballistic-Helmets-
FIG-1

Remove Velcro pads from helmet shell interior. Leave any hard foam impact liners in place (such as Ops-Core TM LUX Liner).
Align centerline of CWL TM with centerline of helmet shell.
Carefully spread CWL TM across interior Velcro of helmet shell. Ensure material is as smooth and flat as possible to minimize pad displacement in step four.
Replace pads in interior of CWL TM in the same configuration as before.
NOTE: if helmet is properly sized for user, use of the same pads with and without the CWL TM is likely. If the user’s helmet runs smaller than factory recommendation. thinner pads may be necessary for proper fit when CWL TM is installed.

UNITY-Tactical-Cold-Weather-Liner-for-Ballistic-Helmets-
FIG-2

Keep CWL TM folded in half and align front center seam with center of helmet brim. Lower portion of CWL TM should extend below shell brim on most helmets. Align rear CWL TM seam with center of helmet rear edge. Carefully engage the “spine” of the CWL TM w?h Velcro running down the center of the helmet shell.
NOTE: If helmet features a fold-over brow pad (such as Ops-Core TM liners). align bottom front edge of CWL TM w?h helmet lip to allow brow pad to fold back in.

UNITY-Tactical-Cold-Weather-Liner-for-Ballistic-Helmets-
FIG-3

Carefully spread out the right and left sides of the CWL TM into helmet shell. Take care to avoid wrinkles. ensuring material is as smooth as possible. This may require several attempts to achieve the smoothest
results. It is most easily done by starting in the center and working your way out to the edges.
NOTE: Due to the elasticity of the fabric. the CWL TM may not completely engage all Velcro in some helmet shells.
@Copyrii/1121120.UNITYTactioal AIRightsReseMd.

UNITY-Tactical-Cold-Weather-Liner-for-Ballistic-Helmets-
FIG-4

When satisfied with CWL TM installation. begin reinstalling pads. Begin with largest pads and work your way to the smallest.
NOTE: Some wearers may possess a helmet that leans on the smaller side of the size spectrum. If your helmet is smaller than factory recommendations for your head, you may need to install a thinner size pad when the CWL TM is present for optimal fit.
@Copyrii/1121120.UNITYTactioal AIRightsReseMd.

UNITY-Tactical-Cold-Weather-Liner-for-Ballistic-Helmets-
FIG-5

Remove CWL TM by grasping entire liner / pad assembly and slowly pulling it out of the shell. Take care to not tear fabric or st?ching. Once removed, pull pads out of CWL TM and replace them in helmet.

Read User Manual Online (PDF format)