havit HV1428W Spitze Black 3w LED Garden Spike Light Instruction Manual
- June 4, 2024
- havit
Table of Contents
HV1428W Spitze Black 3w LED Garden Spike Light
Instruction Manual
Important Safety Issues:
- This product must be installed by a qualified electrician according to AS/NZS 3000.
- Ensure all electrical mains are disconnected before any installation. Modification of this product will void any warranty.
- Flat Lighting does not take responsibility for wrong installation, incorrect use, or use of installation material that does not belong to the system.
- All electrical connections must be watertight, If a watertight connection is not done, the Warranty will be voided.
- When installing low voltage fittings, Voltage to fitting must be within +or- 5% of voltage required and cannot be installed more than 25m from LED Driver, if not within this allowance warranty will be voided.
- Aluminum and 304SS fittings must not be installed within 5km of any saltwater environments.
- All 316 stainless steel fittings must have regular cleaning maintenance to avoid any tea staining from forming on the fitting. (Warranty does not cover Tea Staining).
- All o-rings and seals must be in place correctly to maintain the warranty.
- These instructions may be updated at any time due to product improvements, Please visit the website for the most current installation instructions.
Steps for Installation:
- Make sure that the electrical circuit is free of voltage (master switch off)
- Place fitting in the desired location
- Connect the cable –
- Use an appropriate 12v DC LED Driver – DO NOT CONNECT LIGHT FITTING DIRECT TO 240V
- Strip back cable on both fittings and cable run and twist the positive cable from fitting to positive on the cable run, then connect neutral from fitting to neutral on the cable run.
- Solder all joins using solder with either a heat gun or butane gas torch.
- Cover connections using an adhesive-lined heat shrink or gel cap to make the connection watertight. (failure to do this step will void the warranty)
- Heat the heat shrink or crimp the gel cap making sure all connections are covered.
- Adjust fitting to the desired position making sure to stop rotating when fitting cannot rotate anymore, If forced fitting will continue to rotate and cause internal cables to become entangled causing fitting to short. If this is done, the warranty will be voided.
- All connections must be carried out carefully, inspect all contacts before switching back on the electric circuit.
Dimensions
Product Specifications
| Model No. | HV1428W | HV1428N | HV1428C |
|---|---|---|---|
| Name | Spitze | ||
| Material | Aluminum | ||
| Colour | Black | ||
| IP Rating | IP65 | ||
| Input Voltage | 12v DC | ||
| Lamp Base | Built-in LED | ||
| Lamp Wattage | lx 3w | ||
| Colour Temp | 3000k | 4000k | 5500k |
| Lumens | 2751m | 3001m | 3101m |
| CRI | > 80 | ||
| Wiring | Parallel | ||
| Dimmable | No | ||
| Warranty | 3 Years Replacement* |
Must be installed by a licensed electrician
| Warranty Terms & Conditions* | Additional Information |
|---|---|
| https://havit.com.au/pages/warranty-terms-and-conditions |
Contact Details:
143 Beauchamp Road
Matraville NSW 2036
Australia
Tel: 02 9381 8300
Fax: 02 9666 8881
Email: sales@havit.com.au
Web: www.havit.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>