FLYSMART Digi C187 RC Helicopter User Manual

FLYSMART Digi C187 RC Helicopter User Manual

Important Note

Please read the manual to learn the function of the this product before operation. Damage to the product and potential personal injury may occur if you make an operational error.

This is a RC helicopter, not a toy. You should not only have a prudent operation, but also to have an operational basis. All children using it should be under adult supervision.  The manual includes safety, operation and maintenance. In order to avoid causing damage or serious injury, please obey the instructions and warnings before you using this product.

Additional Safety Precaution And Warnings

1. Recommended age of users: Not suitable for children under 14 years old.
2. Operate it in an open space, away from the traffic and people.
3. Obey the instructions and warnings, includes the use of optional equipment.
4. It has to stay away from chemicals. Small parts and electric equipment must be out of thereach of children.
5. Keep away from water because this product has no waterproof function.
6. Do not put any parts in the mouth, it will cause injury or death.
7. Don’t operate the model if the transmitter’s battery is in low voltage.
8. Don’t view the beam of the light emitting diodes, it would effect the eyesight.
9. The motor and electric equipment will be heat after flight. Please do not touch them to avoid scald.
10. In order to avoid causing damage, please do not touch the high-speed.

Warning And The Of Using Battery

Note: Using the original factory USB charger can ensure charging safety. Suggest you use the original factory USB charger part, other chargers may cause battery damage and property damage.

Warnings! The battery will fire, explode or leak if not strictly observing this item described below. :

1. Do not immerse the battery in water or seawater, and keep the battery in a cool dry environment during stands by period.
2. Keep all batteries out of the reach of little children. Consult a doctor immediately if a battery is swallowed.
3. Do not use or leave the battery near a heat source such as fire or heater.
4. Use the battery charger specifically for that purpose when recharging.
5. Do not reverse the positive (+) and negative (-) terminals.
6. Do not connect the battery to an electrical outlet.
7. Do not dispose the battery in fire or heat.
8. Do not short-circuit the battery by directly connecting the positive (+) and negative (-) terminals with metal objects such as wire.
9. Do not transport or store the battery together with metal objects such as necklaces, hairpins etc.
10. Do not strike or throw the battery against hard surface.
11. Do not directly solder the battery.
12. Do not unpack the battery with a nail or other sharp object.
13. Never disassembling the battery in any way

Note: The battery can not be placed for a long time under full power and low power. Otherwise, the battery will not be charged or the battery will be wrapped. For long-term storage, please charge the battery to 7.8V and store it in a dry and safe place.

Helicopter Parameters

Dimensions

Packing List

1. Helicopter
2. Remote Control
3. Lipo battery
4. USB charge
5. Phillips screwdriver + hex wrench
6. Upper connecting rod / Propeller / tail rotor
7. Instruction manual

Introduction Of Transmitter Function

Parts

Batteries Charging Method

Charging Method 1:
Charging Battery by the USB port on a computer.

Description

1. Connect the USB charger with USB port.
2. Connect the battery with USB charger: LED on when charging, LED OFF when charging finished

Charging Method 2:

Charging Battery by power supply adapter.

Description

1. Connect the USB charger with power supply adapter.
2. Connect the battery with USB charger: LED on when charging, LED OFF when charging finished

Charging Method 3:
Charging Battery by power bank

Description

1. Connect the USB charger with power bank .
2. Connect the battery with USB charger: LED on when charging, LED OFF when charging finished

First Flight Preparation Caution

1. ensure suffcient power supply of the transmitter and helicopter.
2. Keep a flight in a suitable space which away from the traffic, people, electricity pylons and pool.
3. Do not lock the main rotor screws too tightly to keep folding smoothly. If the main rotor screws are too tight, the helicopter will shake when flying.
4. Under emergency situation, you can press “sharp stop” button for 3″ to land the helicopter without rotating. ( Note: this acticon may cause helicopter crash.)
   

Installation Method Of Remote Controller Battery

Direction of operation

If you are unfamiliar with the control of the C187, take time to familiarize it before your first flight.

Throttle

Rudder left

Elevator

Alieron

Flight Operation Steps

1. Turn on the transmitter and let helicopter stay near to transmitter.
2. Install the aircraft battery in the battery compartment safely and securely. Press the power switch for 2 seconds to turn on the aircraft power.
3. The lights of the helicopter and the remote control flash at the same time. Then push the throttle stick from top to bottom quickly. The remote control makes a ‘DI’ sound, and the indicator lights of the helicopter and remote control are always on, which means binding successful.
4. Pull the two joysticks to outer eight angles to start the helicopter. (You can also press the one-key takeoff button to take off the helicopter directly.)
5. Keep the helicopter head forward, and keep safe distance with the helicopter.
6. When manually operating the aircraft to land, please keep the throttle stick at the bottom for 2-3 seconds, and then release it after the propeller has completely stopped rotating. (This operation is not required when using the one-key landing function)

Note:

1. In order to avoid hitting, do not look at the helicopter at hip level when it fly.
2. In order to avoid distractions, please confirm without other transmitters at work around.

Corresponding to step 1C

Corresponding to step 3C

Corresponding to step 4

Note: Beginner should pay attention to the direction of flight. Keep the head forward to avoid causing injury

Flight Yaw correction method

Press the triming button when helicopter has yaw problems.

The helicopter has set up hovering. If you are dissatisfied with hovering or the helicopter have a yaw, please follow there steps to adjust.

Take off with the throttle joystick. According the direction of yaw, press the fine-tuning button in the opposite direction until the plane hovering.

Forward/ backward Yaw| | | Fine-tune according to the direction of the arrow
---|---|---|---
Left/right Yaw| | | Fine-tune according to the direction of the arrow
Side fly Yaw| | | Fine-tune according to the direction of the arrow

Trimming Notes

Introduction of the corresponding socket of receiver

Gyro calibration method

1. When flying yaw, first land and calibrate the gyroscope.
2. When calibrating the gyroscope, the aircraft must be placed on a level ground.
3. The indicator light will flash quickly during the calibration process, the indicator light stops flashing to take off.

Commonly used parts replacement instructions

Remove the propeller with a hex wrench, Be careful not to be too tight when installing the new propeller

Unplug the plug, then twist the motor left and right to pull out

First pull out the screw, and then pull out the big gear directly downward. Pay attention to the direction when installing the new gear. The plane of the shaft should be aligned with the plane of the inner hole of the gear.

When removing and replacing the tail rotor, please pay attention to the direction, align the motor shaft and press it slowly to ensure smooth rotation.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>