TRAXXAS TRA9080X Outer Driveline and Suspension Upgrade Kit Instruction Manual
- June 4, 2024
- Traxxas
Table of Contents
**TRAXXAS TRA9080X Outer Driveline and Suspension Upgrade Kit Instruction Manual
**
Installation instruction
Covers Parts #9080, 9080G, 9080R, 9080T, 9080X
Notbe: The Extreme Heavy Duty Upgrade Kit must be used in its entirety and
is not compatible with some existing Traxxas replacement or upgrade parts.
FRONT ASSEMBLY
Installation
- Remove the wheel/tire and wheel hex.
- Remove the steering block.
- Remove the caster block (c-hub).
- Remove the driveshaft assembly.
- Adjust the camber link (turnbuckle) length to 81mm.
- Remove the shock tower.
- Repeat steps 1-5 for the other side.
- Installation of the parts is the reverse of removal.
Note: If using the #9051X front or 9052X rear accessory steel CV driveshafts, #9053 front or 9054 rear heavy-duty stub axles are required (both sold separately). The #6851R front and 6852R rear accessory steel CV driveshafts are not compatible with the Punisher Pack.
Use included hardware in these locations.
Left Hand Thread Indicators
All of the turnbuckles on the truck should be installed so the left hand
thread indicators point to the same direction. This makes it easier to
remember which way to turn the wrench to increase or decrease turnbuckle
length (the direction is same at all four corners). Note that the groove in
the hex indicates the side of the
turnbuckle with the left-hand threads.
REAR ASSEMBLY
Installation
- Remove the wheel/tire and wheel hex.
- Remove the stub axle carrier.
- Remove the driveshaft assembly.
- Remove the shock tower.
- Repeat steps 1-3 for the other side.
- Installation of the parts is the reverse of removal.
Use included hardware in these locations.
Support
Scan Me
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>