IKEA TRÅDFRI LED Driver Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA TRÅDFRI LED Driver
Product Information
- Type: ICPSLC24-10JP-IL-2
- Input: 100-120 VAC, 50/60 Hz, 0.13 A
- Output: 24.0V DC
- Max total load: 0.42 A, 10.0 W
- Radio range: 10 m in the open air
- Operating frequency: 2405-2480 MHz
- Output power: 8 dBm
- Manufacturer: IKEA of Sweden AB
Product Usage Instructions
To pair a steering device to your product
- Connect at least one (1) product to the mains before you begin the pairing. Make sure that the mains power is turned ON.
- Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
- Press and hold the pairing button on the steering device for at least 10 seconds. A red LED light will shine steadily on the steering device. The product will begin to dim and flash one time to indicate that it has been paired to the steering device.
To factory reset your driver
If the product does not respond or if you want to unpair the product from a steering device, you might have to perform a factory reset. The unit is forced to factory reset by carefully pushing and holding the small button (marked RESET) with the tip of the pen on the LED driver enclosure and applying slight pressure. Care Instructions: To clean the unit, wipe with a dry soft cloth. Never use abrasive cleaners or chemical solvents as this can damage the product. Product Servicing: Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Indoor Use Only Disposal Instructions: The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
If you have the TRÅDFRI gateway or DIRIGERA hub
Go to App Store or Google Play and download the IKEA Home smart app. The app
will take you through the process of installing your product and other
devices.
How to steer your lighting
- When the product is connected to the mains, it is possible to turn it ON/OFF with the main switch or the foot switch, but if you want to dim or connect your product to other IKEA Home smart products, you need to buy a separate steering device (e.g. a remote control).
- The steering device needs to be paired with your wireless product. If you have more than one (1) wireless product, you can pair each one with the steering device so that the entire combination can be turned ON/OFF or dimmed at the same time.
Pairing a steering device to your product
- Connect at least one (1) product to the mains before you begin the pairing. Make sure that the mains power is turned ON.
- Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
- Press and hold the pairing button on the steering device for at least 10 seconds. A red LED light will shine steadily on the steering device. The product will begin to dim and flash one time to indicate that it has being paired to the steering device.
How to factory reset your driver
If the product does not respond or if you want to pair the product with a steering device, you might have to perform a factory reset. The unit is forced to factory reset by carefully pushing and holding the small button (marked RESET) with a tip of pen on the LED driver enclosure and applying slight pressure.
IMPORTANT!
- The product is for indoor use only and can be used in temperatures ranging from 5 °C to 45 °C.
- Do not leave the product in direct sunlight or near any heat source, as it may overheat.
- The declared radio range between the unit and the steering device is measured in the open air.
- Different building materials and the placement of the units can affect the wireless connectivity range.
Care instructions
- To clean the unit, wipe it with a dry soft cloth.
- Never use abrasive cleaners or chemical solvents as this can damage the product.
Product Servicing
- Do not attempt to repair this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks.
Save these instructions for future use.
Technical data
- Type: ICPSLC24-10JP-IL-2
- Input: 100-120 VAC, 50/60 Hz, 0.13 A
- Output: 24.0V DC
- Max total load: 0.42 A, 10.0 W
- Radio range: 10 m in open air.
- Operating frequency: 2405-2480 MHz
- Output power: 8 dBm
Indoor use only
- Manufacturer: IKEA of Sweden AB
- Address:
- Box 702, SE-343 81 Älmhult, SWEDEN
The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.
© Inter IKEA Systems B.V. 2022 AA-2370834-2.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>