IKEA 003.997.35 BÄVE LED Ceiling Track Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA 003.997.35 BÄVE LED Ceiling Track
Product Information
The product is a lighting device that uses nonchangeable light diodes (LED) as the light source. The device complies with part 15 of the FCC Rules and is designed to operate without causing harmful interference. However, it must accept any interference received, including interference that may cause undesired operation. The device is not to be disassembled, and it should not be immersed in water. It is recommended to clean the device using a damp cloth and never a strong cleaning agent.
Product Usage Instructions
- Before starting, turn off power at the main circuit panel.
- Ensure that the device is properly grounded by connecting the earth/ground wire to an appropriate grounding point.
- Connect the live wire to the corresponding terminal marked “Live.”
- Connect the neutral wire to the corresponding terminal marked “Neutral.”
- After installation, turn on the power at the main circuit panel to operate the device.
- If cleaning is required, use a damp cloth to wipe down the device. Do not use a strong cleaning agent.
Note: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Keep these instructions handy for future reference.
Safety Instructions
CAUTION :
Before starting, turn off power at main circuit panel.
CAUTION!
The light source of this product is non-changeable light diodes (LED).
Do not disassemble the product, as the light diodes can cause damage to the
eyes.
Do not immerse in water.
Cleaning
Use a damp cloth, never a strong cleaning agent.
FCC
This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Assmebly
