IKEA HAMNSKAR Bath Faucet with Strainer Instruction Manual
- October 30, 2023
- Ikea
Table of Contents
IKEA HAMNSKAR Bath Faucet with Strainer
Product Information
The product is a mixer tap that needs to be installed according to the local
construction and plumbing regulations. The installation process should be done
by professionals, and if there is any doubt, it is recommended to contact an
expert. The product comes with instructions in various languages, including
English, Nederlands, Polski, Latviesu, Lietuvi, Hrvatski, Srpski, Slovenscina,
Bahasa Indonesia, and Bahasa Malaysia.
The mixer tap comes with hoses, pipes, and washers that can get damaged if
tightened too hard. Therefore, it is advised not to over-tighten the tap.
Before changing the mixer tap, it is essential to switch off the main shut-off
valve to avoid any water leakage.
The product’s operating pressure ranges from 14.5 – 72.5 psi (1 – 5 bar) to
7.2 – 145 psi (0.5 – 10 bar).
Product Usage Instructions
- Ensure that the installation is in compliance with the current local construction and plumbing regulations.
- Switch off the main shut-off valve before changing the mixer tap.
- Follow the instructions provided in the user manual in the preferred language.
- Do not tighten the hoses, pipes, and washers too hard to avoid any damage.
By following these instructions, users can ensure safe and optimal usage of
the product.
Installation must be performed in compliance with current local construction
and plumbing regulations. If in doubt, contact a professional.
Parts & Hardware
Assembly
IMPORTANT! Do not tighten too hard: this can damage
hoses/pipes and washers.
Before use: Unscrew the Aerator/Flow Guide and allow the water to run
freely for a few minutes. Then screw the Aerator/Flow Guide back in place.
Ensure that it is tight to prevent removal by hand.
Check at
regular intervals to make sure that the installation is not leaking.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>