DOMETIC 30A Deluxe Roof Mounted User Guide
- June 4, 2024
- Dometic
Table of Contents
DOMETIC 30A Deluxe Roof Mounted
INSTALL SAFETY
- Inspect the installation area for safety hazards.
- Be sure to remove all metal such as rings and other jewelry.
- Disconnect all power sources and ensure solar panels are completely covered by a box or blanket until installation is done
INSTALL TOOLS
- Flat head screwdriver
- Philips head screwdriver
- Wire stripper
- Decor
INSTALL INSTRUCTIONS
- Arrange the layout of your panels and wire, ensuring that:
- 3-port roof cap is no more than 15’ from charge controller.
- panel wires can reach 3-port roof cap.
- charge controller is no more than 10’ from the battery.
- panels are not shaded by vents, A/C units, or other obstructions.
- Connect 15’ Solar wire(s) to the 3-port roof cap(s).
- Strip the ends of both positive and negative wires 1/2 inch.
- Screw the red (+) wire into the corresponding positive terminal, the black (-) wire into the corresponding negative terminal.
- Mount 3-port roof cap(s) and route the 15’ cable(s) from the roof to the charge controller location.
- Do not make connections at this time.
- Attach mounting feet to panels. Proceed with panel installation.
- Connect the negative battery wire to the charge controller, then connect the battery positive wire through an overcurrent protection device (40A fuse/circuit breaker) to the charge controller as shown below.
- Proceed to route the 10’ cable from the charge controller to the battery.
- Connect the positive and negative battery wires to the battery as shown below and verify the charge controller turns on.
- Connect the positive and negative solar wires to the charge controller.
- Mount your charge controller.
- Configure your charge controller to the proper battery type.
- You may now plug the SAE leads into the 3-port cap and uncover the panels.
- You are now charging your battery.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>