Metalcraft TFB-Trailer-1 Boat Trailer Instruction Manual
- October 30, 2023
- Metalcraft
Table of Contents
TFB-Trailer-1 Boat Trailer
Instruction Manual
We appreciate your purchase of our Trailers. Please follow these few simple
instructions. Instructions should be kept in a safe place and reviewed at
least annually.
We offers a one year limited warranty to be free from defects in materials and
workmanship for the service life of the product, not to exceed twelve
consecutive months from the date of purchase.
The Jack, fence, tool box and linear are optional items. If you do not
purchase the corresponding product, please ignore their installation steps.
ASSEMBLY INSTRUCTIONS
Tools needed – An adjustable wrench
IMPORTANT ASSEMBLY TIP: Do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! This will temporarily hold the lock nut on the bolt
while helping alignment of all parts! After all parts are assembled together,
all nut & bolt combinations must be completely tightened.
- Install the rear prop, using 2-M10*70 bolt, 2-M10 nut, 2-⌀10 washer, 2-⌀10 spring washer.
- Install the frame and rear wheel bracket together, using 2-M10*70 bolt, 2-M10 nut, 2-⌀10 washer, 2-⌀10 spring washer.
- Install the front prop, using 2-M10*40 nut, 2-M10 bolt.
- Install the V plastic part, using M10 nut, M10*90 bolt.
- Install the draw bar and winch base, using 2-M10*120 bolt, 2-⌀10 spring washer, 2-⌀10 washer, 2-M10 nut.
- Install the mudguard, using 8-M8 nut, 8-M8*20 bolt.
- Install the tire, using 8-M12 nut.
- Install the winch, using 2-M8 nut, 2-M8*20 bolt.
- Install the draw bar and frame together, using 2-M10*90 bolt, 2-M10 nut, 2-⌀10 washer, 2-⌀10 spring washer.
- Install the drive pipe on the rear prop, using 2-M10*40 bolt, 2-M10 nut.
ASSEMBLY DRAWING
Attention:
For the linear actuator
This item is designed for certain application only. The distributor cannot be
responsible for issues arising from modification. We strongly recommend this
item not be modified and /or use for any application other than that for which
it was designed.
General safety rules **
**
WARNING: Read and understand all instruction. Failure to follow all
instructions listed below may result in serious injury.
WARNING: The warnings, cautions, and instructions discussed in this
instruction manual cannot cover all possible conditions or situations that
could occur. It must be understood by the operator that common sense and
caution are factors which can’t be built into this product, but must be
supplied by the operator.
WARNING
READ, UNDERSTAND AND FOLLOW ALL ASSEMBLY, INSPECTION, MAINTENANCE & USE
INSTRUCTIONS PROVID- ED BEFORE EACH USE. FAILURE TO FOLLOW ALL WARN- INGS AND
INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
DOUBLE CHECK THE ASSEMBLY OF YOUR TRAILER TO BE SURE YOU ASSEMBLED IT
CORRECTLY AND ALL NUT & BOLT ASSEMBLIES ARE TIGHT BEFORE INITIAL USE.
BE SURE TO PERIODICALLY CHECK ALL NUT AND BOLTS FOR TIGHTNESS. OVER TIME, NUTS
AND BOLTS MAY BE- COME LOOSE FROM VIBRATION.
BE SURE TO ALWAYS HAVE THE CORRECT AMOUNT OF AIR PRESSURE IN TIRES. THIS WILL
HELP DETER FROM UNNECESSARY WEAR AND/OR DAMAGE. AIR PRESSURE CAN BE FOUND ON
SIDEWALL OF TIRE. NEVER DRIVE ON HILLY TERRAIN – EXCESSIVE WEIGHT CAN CAUSE
WEIGHT SHIFTS WHICH CAN LEAD TO LOSS OF CONTROL OF YOUR ATV AND/OR ATV
TRAILER.
DO NOT DRIVE IN EXCESS OF 10 MPH WHILE USING THIS PRODUCT.
NEVER ALLOW PEOPLE OR ANIMALS TO RIDE IN THE ATV TRAILER! IT IS NOT DESIGNED
FOR THAT MATTER.
USE CAUTION NEAR TRAILER TILT LATCH. BE SURE LATCH IS ENGAGED BEFORE EACH USE.
Never…
- se excessive speeds while towing trailer.
- Exceed the maximum load capacity of 500KGS.
- Allow people or animals to ride in trailer.
- Use on hilly terrain.
- Use a damaged product.
- Use when intoxicated or using over-the-counter medication or prescription drugs.
- Use on rocky or obstacle ridden terrain.
- Use carelessly — Think Safety!
TFB-Trailer-2 boat trailer Part List
NO. | DESCRIPTION | QTY |
---|---|---|
1 | M10*70 bolt | 4 |
2 | M10 nut | 11 |
3 | ⌀10 washer | 8 |
4 | ⌀10 spring washer | 8 |
5 | M10*40 nut | 2 |
6 | M10 bolt | 2 |
7 | M10*90 bolt | 3 |
8 | M10*120 bolt | 2 |
9 | M8 nut | 10 |
10 | M8*20 bolt | 10 |
11 | M10*40 bolt | 2 |
12 | M12 nut | 8 |
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>